为了获得访问"阿拉丁铁蛋"实时聊天框的流畅支持体验，建议您使用Chrome浏览器或选择360浏览器极速模式(如何切换极速模式?)，感谢您选择我们！
| 货号 (SKU) | 包装规格 | 是否现货 | 价格 | 数量 |
|---|---|---|---|---|
| B283710-500g |
500g |
现货  |
|
| 别名 | 聚酰胺56 |
|---|---|
| 规格或纯度 | 生物基含量45% |
| 英文名称 | Bio-based Polyamide Resin56 |
| 产品介绍 |
典型应用 该材料可用作改性基料或注塑原料。 使用指南 1.本产品的包装为防潮包装，在未开封前水分含量恒定，建议开封后尽快使用。在使用已开封的产品前，建议对其进行必要的除湿干燥，以确保注塑制品质量和注塑过程的稳定性。干燥温度不宜过高，最高不应超过110℃时间不宜过长，最长不应超过5小时。 2.注塑温度不宜过高，建议以270℃-295℃为宜。过高的温度容易使生物基聚酰胺树脂在高温状态下裂解，产品性能下降。 3.在注塑生产过程中，模具温度以600℃-900℃为宜，建议模具温度保持在温度区间的上限，过低的模具温度会导致生物基聚酰胺树脂流动性变差，制品表面光洁皮差、表面缺陷、制品收缩率高或脆断导致品质下降等等。 Typical applications The material can be used as a modified substation or injection molding raw material. 1.The packaging of this product is moisture-proof packaging, the moisture content is constant before unopacking, it is recommended to use as soon as possible after opening. Before using the opened product, it is recommended that it be dehumidification and drying as necessary to ensure the quality of the injection molding products and the stability of the injection molding process. Drying temperature should not be too high, the maximum should not exceed 110℃ and the time should not be too long, the maximum should not exceed 5 hours. 2.Injection molding temperature should not be too high, it is recommended to 270℃-295℃. Too high temperature easily makes bio-based polyamide resin crack at high temperature, product performance is reduced. 3.In the injection molding production process, the mold temperature to 600℃-900℃ is appropriate, it is recommended that the mold temperature remain at the upper limit of the temperature range, too low mold temperature will lead to bio-based polyamide resin flow worse, product surface finish poor skin difference, surface defects, product shrinkage or brittleness lead to quality decline and so on. |
| 熔点 | 260-290℃ |
|---|
输入批号以搜索COA:
首页
400-620-6333
危险品化学品经营许可证（带存储）