Thermoelectric devices (TEDs) show great potential for waste heat energy recycling and sensing. However, existing TEDs cannot be self-adapted to the complex quadratic surface, leading to significant heat loss and restricting their working scenario. Here, surface-conformable origami-TEDs (o-TEGs) are developed through programmable crease-designed origami substrates and the screen-printing TE legs. Compared with “π” structured TEDs, the origami design (with heat conductive materials) changed the heat-transferring direction of the laminated TE legs, resulting in an enhancement in enlarging Δ T / T Hot and V out by 5.02 and 3.51 times. Four o-TEDs with different creases designs are fabricated to verify the heat recycling ability on plane and central quadratic surfaces. Demonstrating a high V out density (up to 0.98 −2 at Δ T of 50 K) and good surface conformability, o-TEDs are further used in thermal touch panels attached to multiple surfaces, allowing information to be wirelessly transferred on a remote display via finger-writing.
Perovskite has shown attractive optoelectronic performances and is a potential material in lighting, anti-counterfeiting, sensor, and other optoelectronic devices. Recently, spin-coating has been widely used in fabricating high-performance perovskite films, but it is difficult to process and apply in practice. In this paper, the CsPbBr 3 /Cs 4 PbBr 6 composite perovskite quantum dots with photoluminescence quantum yield of 36% and high storage stability were prepared by using room temperature ligand-assisted precipitation method and controlling the proportion of CsBr/PbBr 2 . In addition, the composite perovskite was ground and dispersed in the inks system. After adjusting the composition and ratio of the resin components, the inks were suitable for screen printing with a viscosity of 2439 mPa•s, an initial dryness of 25 mm/30 s, and a thorough dryness of 100 s/100 μm. By printing, the perovskite films exhibited high coverage, strong green emission, and outstanding fluorescence recovery ability after exposure to water. Screen printing perovskite inks have the characteristic of being patternable, which provides a solution for preparing a perovskite film in the application.
危险品化学品经营许可证（带存储）