Amino acids (AAs) account for about 15–35% of dissolved organic nitrogen (DON), and are known as the important precursors of nitrogenous disinfection by-products (N-DBPs). Determining the formation potential (FP) of AAs to DBPs is used to reveal the key precursors of DBPs for further control, while the ideal method for N-DBPs FP of AAs during chlorination is not revealed. In this study, the ideal FP test models for five classes of priority DBPs during chlorination of four representative AAs (accounted for about 35% of total AAs) were analyzed. For haloaldehydes (HALs), haloketones (HKs), haloacetonitriles (HANs), haloacetamides (HAMs), and halonitromethanes (HNMs), their FPs during chlorination of four AAs were 0.1–13.0, 0.01–1.1, 0.1–104, not detectable (nd)-173, and nd-0.4 μg/mg, respectively. The FPs of priority DBPs had significant deviations between different FP test models and different tested AAs. For HALs, the model, whose chlorine dosage was determined by 15 × molar concentration of AAs [Cl (mM) = 15 × M](named: model II), was the ideal model. For HKs, model II was also the ideal FP test model for AAs with ≤3 carbons, while for AAs with 4 carbons, the model, whose chlorine dosage was determined by keeping the residual chlorine at 1 ± 0.2 mg/L after 24 h of reaction (named: model 4), was the ideal model. For HANs and HNMs, model 4 was the ideal FP test model for most of the studied AAs. The performance of HAMs during chlorination of amino acids was totally different from other P-DBPs, and model 3 was recommended to be the ideal model, in which chlorine dosage was determined by 3 × mass concentration of AAs [Cl (mg/L) = X × DOC]. This study is a reference that helps researchers select an ideal model for N-DBPs FP study of AAs.
Li Siwen,Lin Yingzi,Wang Gaoqi,Zhu Suiyi,Liu Gen,Shi Chunyan,Chen Lei
This study researched the formation of disinfection by-products (DBPs) in sulfamethazine (SMZ) chlorination after preoxidation by K2FeO4 and O3 and the influence of preoxidation on cytotoxicity and biological toxicity. Then, the study emphatically analyzed the influencing factors such as NaClO dosage, pH value, reaction temperature, fulvic acid (FA), and bromide and iodide ions. The results showed that preoxidation by K2FeO4 effectively inhibited the formation of DBPs of haloketones (HKS) and trihalomethanes (THMs), with an average inhibition rate of over 60%. The formation of DBPs after preoxidation by O3 was higher than that by K2FeO4; preoxidation by K2FeO4 reduced the influence of NaClO dosage, temperature, and pH value on the production of DBPs after SMZ chlorination. The cytotoxicity and biological toxicity of SMZ chlorination after preoxidation were evaluated and compared by calculating the LC50 value of DBPs and the luminescent bacteria method. The results of both calculation methods showed that the toxicity of DBPs after preoxidation by K2FeO4 was lower than that by O3 preoxidation. K2FeO4 and O3 preoxidation improved the SMZ removal efficiency by 8.41 and 10.49%, respectively, and inhibited the formation of most DBPs, but the preoxidation promoted the formation of highly toxic DBPs (HANs). The toxicity of DBPs formed in SMZ chlorination after preoxidation by K2FeO4 and O3 was slightly higher than that of chlorination disinfection alone, but it was still within the safe range. This study provides more new details about the formation and toxicity changes of DBPs in the process of SMZ chlorination after preoxidation.
危险品化学品经营许可证（带存储）