Removal of fluoride and chloride from waste acid by Bi2O3: comparison between the synchronous and two-step methods
Removal of chloride (Cl(− I)) and fluoride (F(− I)) ions is a major issue in metallurgical waste acid recycling. This study explored the synchronous and two-step precipitation approaches using bismuth oxide (Bi 2 O 3 ) to remove Cl(− I) and F(− I). Under the mole ratio of Bi 2 O 3 and halide ions at respectively 0.3 and 0.7 for the first and second steps, residual concentrations of Cl(− I) and F(− I) below 100 and 50 mg/L, respectively, were obtained, where the removal proportions of Cl(− I) and F(− I) in the first and second steps were respectively 1:1.1 and 1:3.3. During the treatment, Bi 2 O 3 was dissolved to produce Bi 3+ , which reacted with Cl(− I) first and then F(− I), leading to the precipitation of bismuth oxychloride and bismuth oxyfluoride. After the removal of Cl(− I) and F(− I), residual Bi 3+ was removed to a final concentration of 1.3 mg/L through introduction of hydrogen sulfide (H 2 S) and recovered as bismuth sulfide (Bi 2 S 3 ). In this method, approximately 97.6% of Bi 2 O 3 was regenerated, additionally, Cl(− I) and F(− I) were transferred to a NaOH/NaCl/NaF concentrate with minimal volume. This two-step approach for the removal of Cl(− I) and F(− I) using Bi 2 O 3 exhibited excellent performance in terms of high efficiency, high reagent recovery rate and low secondary pollution risk.
危险品化学品经营许可证（带存储）