Jing Zhang,Ling Ai,Shenghua Lin,Pinjun Lan,Yuehui Lu,Ning Dai,Ruiqin Tan,Bin Fan,Weijie Song
Antireflection (AR) coatings on solar glass, used in photovoltaic (PV) modules, generally encounter harsh environments, which demands that AR coatings must hinder moisture penetration , scratch damage, and dust accumulation. Though chemical modification generally benefits the multi-functionalization of AR coatings, it is likely to bring about a degradation of optical and mechanical properties. We demonstrated that a well-controlled dual precursor modification/hybridization process of hollow silica nanospheres was the key to achieve the robust multifunctional AR coatings. The dual precursor-derived AR coatings exhibited an increase of 5.08% in average transmittance at wavelengths from 300 to 1200 nm and a small relative reduction below 0.6% after an ultra-long highly-accelerated humidity and temperature stress test duration of 120 h, equivalent to a 5000 h damp heat test at a temperature and a relative humidity of 85 °C and 85%, respectively, as well as the excellent abrasion and dust resistance. The effects of the dual precursor-derived AR coatings on PV devices were evaluated by the encapsulated crystalline silicon mini-modules, where the improvements of 2.45% and 3.20% in the short-circuit current and the power conversion efficiency ( J sc and PCE) on average, respectively, relative to the bare glass encapsulated mini-modules were observed; meanwhile, the dust resistance of the AR coatings brought about the less degradations of 1.01% and 1.15% in J sc and PCE, respectively, after the dust settling and removal tests, while the mini-modules with bare glass were 3.45% and 4.40%. It was believed that the dual-precursor, potentially, multi-precursor protocols would pave the way towards developing mechanically robust AR coatings with various fascinating functionalities, such as anti-fingerprint, anti-soiling, anti-fogging, and anti-icing.
Xiaoyu Sun,Lei Li,Xiaozhuang Xu,Guanyu Song,Jielei Tu,Pingyuan Yan,Weinan Zhang,Kai Hu
Reflection from the surface of solar panels is important factor to limit the efficiency of all of photovoltaic devices . Antireflective coatings (ARCs) can significantly reduce surface reflections and improve photovoltaic module efficiency. But, ARCs on solar glass, used in photovoltaic (PV) modules, usually located in terrible environments, which demands that ARCs must hinder moisture penetration , abrasion damage, and dirt accumulation. In this study, the films with highly antireflective properties that maintains a high durability and hydrophobic were prepared through a simple sol–gel method by using PTFE (Polytetrafluoroethylene) modified. The average transmittance of glass with ARCs was 97.86 % at 400–800 nm, which was an increase of 7.86 % compared to the bare glass. X-ray Diffraction (XRD), Fourier Transform Infrared spectrometer (FT-IR), field emission scanning electron microscope (FE-SEM), ellipsometer , atomic force microscope (AFM), UV–vis-NIR spectrophotometer and water contact angle analyzer were used to measure the surface composition, morphology, refractive index , surface roughness , optical and hydrophilic properties of the coatings. The results revealed that the deposition of PTFE modified SiO 2 coating on the glass substrate had a significant enhance on the antireflection, abrasion-resistance and hydrophobic property.