Optimizing fouling mitigation in membrane distillation by controlled microbubble size and concentration
Fouling control strategies play a crucial role in membrane distillation (MD) process, primarily due to the significant limitation of fouling during the scaling-up process. The utilization of microbubbles (MBs) aeration has exhibited promising potential in mitigating membrane fouling when treating high salinity wastewater. Aeration can introduce gas-liquid two-phase flow on the membrane surface , thereby increasing the membrane surface shear force. The mechanism of aeration technology for controlling fouling includes the following points: introduction of gas-liquid two-phase flow; physical substitution of concentration polarization layer ; pressure pulses caused by bubbles flowing through the membrane surface and increasement of the cross flow velocity. This research aims to optimizing the effect of air MBs with different concentrations and sizes introduced in the feed side on membrane fouling control, we creatively used the method of releasing pressure gradiently to achieve size regulation of MBs within a certain range for the first time, firstly regulated the generation of MBs by manipulating gas flow rate and release pressure. Under the optimal condition of 40 mL/min and 0.6 MPa, it will yield concentration of 1.58 × 10 4 /mL and D50 Sauter size of 64.69 μm MBs with pure water permeance flux of 12.32 kg/(m 2 ·h). It was observed that higher gas flow rates primarily increased MBs concentration, while lower pressures predominantly reduced MBs size through the method of inline imaging. Experimental results indicated that introduction of MBs can slightly improve the temperature polarization coefficient and mass transfer coefficient under different operating modes. Consequently, further investigations focused on the influence of MBs characteristics on different fouling control. All conditions reach 99 % rejection for inorganic salt and HA. This study provided empirical evidence that higher concentration and larger size of MBs intensify the gas-liquid two-phase flow disruption and exhibit a better shear effect on scaling phenomena, which yield advantageous outcomes in terms of augmenting permeance flux and water vapor production, with permeance flux increased from 40.12 % to 55.42 % for inorganic fouling and increased from 68.35 % to 80.15 % for inorganic and HA fouling. These results were confirmed via membrane surface using scanning electron microscopy and energy dispersive spectroscopy. In summary, this research aided in identifying appropriate operating conditions for mitigating inorganic and composite scaling by implementing air-infused MBs in direct contact membrane distillation (DCMD), which provides scientific and technical guidance for controlling fouling in MD in practical applications.
危险品化学品经营许可证（带存储）