The nucleation of graphene at different locations in the quartz boat was studied, and the lowest nucleation density of graphene in the quartz boat was found. The nucleation density of graphene is the lowest at the bottom of the quartz boat near the gas inlet side. Based on the above results, a simple and reproducible way is proposed to significantly suppress the nucleation density of graphene on the copper foil during the chemical vapor deposition process. Placing the copper foil with an area of 1.3 cm × 1 cm in the middle of the bottom of the quartz boat or further back, and placing two copper pockets in front of the copper foil, an ultra-low nucleation density of ~42 nucleus/cm2was achieved on the back of the copper foil. Single-crystal monolayer graphene with a lateral size of 800 μm can be grown on the back of copper foils after 60 min of growth. Raman spectroscopy revealed the single-crystal graphene to be in uniform monolayers with a low D-band intensity.Keywords:single-crystal graphene;nucleation density;quartz boat;copper foils;copper pockets
A large spherulite structure deteriorates the mechanical properties of crystalline polymers, and therefore various methods have been explored to increase primary nucleation density. Recently, chain-end modification has been proposed as an effective approach for regulating polymer crystal nucleation. However, the relevant nucleation mechanism still requires investigation. Therefore, in this work, 2-ureido-4[1H]-pyrimidinone (UPy) units, which can form stacks via quadruple hydrogen bonds with each other, are introduced as end groups for the preparation of interacting telechelic poly(butylene succinate) (PBS-UPy) oligomers with different molecular weights (Mns). The crystallization, especially the nucleation behavior of PBS-UPy, is studied in detail by comparing with the corresponding pre-polymer, the hydroxyl-terminal PBS (PBS-OH). The thermal properties of PBS-UPy exhibit similarMn-dependent tendency to those of PBS-OH, but with weaker total crystallization rate. The spherulite growth rate is significantly reduced, whereas the primary nucleation density is highly promoted, after introducing UPy groups. Further investigation reveals that the mechanism of UPy stacks’ influence on nucleation ability changes from inhibition to promotion with respect toMn. Even under an inhibition of nucleation ability, the final nucleation density is obviously increased because of a significant decline of the growth rate. In addition, the change in the impact of UPy stacks on nucleation ability is speculated to originate from the memory expression feasibility of ordered conformation in the melt during crystallization.
危险品化学品经营许可证（带存储）