Biomass derived wood ash with amine modification for post-combustion CO2 capture
Large quantities of wood ashes derived from biomass materials combustion potentially threaten the ecological environment. Recycling of the wood ashes as solid sorbents for pollutants control is an economical and environmentally friendly route. In this work, waste wood ashes (WAs) were modified with tetraethylenepentamine (TEPA), monoethanolamine (MEA), diethanolamine (DEA), polyethyleneimine (PEI), and diethylenetriamine (DETA) to synthesize solid sorbents with enhanced CO 2 capture performances. CO 2 capture behaviors of the synthesized sorbents were tested under 60 °C, 5.0%CO 2 + 5%H 2 O using a fixed-bed reactor, and sorbent regeneration behaviors were evaluated under 120 °C, 10 °C/min and 100%N 2 . The sorbent synthesized of ashes collected from straw-fired power plants modified with TEPA (TEPA-WA-1) is identified as the optimum candidate with superior capability for CO 2 capture and sorbent regeneration. CO 2 capture capacity of TEPA-WA-1 increases first and then decreases with the increase of amine loading. Sufficient amine loading can provide substantive active sites for enhanced CO 2 chemisorption, whereas excessive loading will cause particle aggregation and pore structure blockage and affect its CO 2 capture capacity adversely. The maximum CO 2 capture capacity of 2.02 mmol CO 2 /g is obtained with an amine loading of 45 wt.%. The desired sorbent is demonstrated to be stable during 10 cyclic operations. Moreover, the presence of acid impurities (SO 2 and NO 2 ) exerts negative effect on the cyclic CO 2 capture and sorbent regeneration performances of the synthesized sorbent. It is mainly attributed to sorbent deactivation induced by the formation of byproducts and weakened physical properties for the sorbent exposed in acid impurities.
危险品化学品经营许可证（带存储）