CRYSTENGCOMM
·
2024
·Vol. 27
·期 5
·661-667
·
IF 2.6
Zhen-Dong Xue,Yi Zhang,Hao-Yu Zhu,Juan-Juan Shao,Qiang Gao,Fang-Ming Wang
Herein, four new cuprous iodide hybrid materials 1–4 were synthesized at room temperature using two types of ligands: imidazoles and triphenylphosphine. Photoluminescence results showed that all the materials exhibited blue emissions with high internal quantum yields (IQYs) ranging from 51% to 64%. Surprisingly, the introduction of triphenylphosphine induced strong aggregation-induced emission (AIE). Additionally, the luminescence lifetimes of these materials were significantly longer, ranging from 11.53 μs to 24.33 μs, which is much longer than those of previous materials. These findings suggest that these materials could be potential candidates for non-rare earth element (REE) lighting phosphors.
研究领域:
材料化学
·
光物理
·
无机-有机杂化材料
·
发光材料
·
非稀土磷光体
✓ 已验证
DOI
高影响因子
PHOTOCHEMICAL & PHOTOBIOLOGICAL SCIENCES
·
2013
·Vol. 12
·期 9
·1628-1635
·
IF 2.923
Li Qiu-Ping,Yan Bing
A series of luminescent polymers are synthesized by incorporating rare earth complex units into polymer matrices. Firstly, we functionalize the selected polymer matrices with the imidazolium moieties, and then introduce the rare earth tetrakis(β-diketonate) complexes into polymer matrices through a mild anion exchange method. The resulting materials are characterized by FTIR, XRD, EDAX, SEM, thermogravimetric analysis, luminescence excitation spectra and emission spectra, luminescence lifetime measurements and diffuse reflectance UV-Vis spectra. The photoluminescence measurements indicate that all these rare earth complex functionalized polymers exhibit a characteristic luminescence emission originating from the corresponding rare earth ions. Among the hybrids, the europium tetrakis(TTA) complex functionalized polymers show remarkable luminescence quantum yields and relatively long 5 D 0 lifetimes at room temperature.
研究领域:
材料化学
·
高分子科学
·
光物理学
·
无机功能材料
·
发光材料
✓ 已验证
DOI
高影响因子
NEW JOURNAL OF CHEMISTRY
·
2020
·Vol. 44
·期 33
·14103-14107
·
IF 3.288
Chanchan Xu,Le Lv,Dawei Luo,Wei Liu
By using pyrazine derivatives, three different types of copper(I) iodide based inorganic–organic hybrid structures, 1D-CuI(2-mo-pz) (1, 2-mo-pz = 2-methoxy-pyrazine), 2D-CuI(2,3-dm-pz)0.5 (2, 2,3-dm-pz = 2,3-dimethyl-pyrazine), and 2D-Cu2I2(2,5-dm-pz)2 (3, 2,5-dm-pz = 2,5-dimethyl-pyrazine), have been obtained by using a slow-diffusion method. Single crystal and powder X-ray diffraction analyses reveal that these hybrid structures are a one-dimensional (1D) staircase chain based structure, two-dimensional (2D) staircase-chain based structure, and 2D rhomboid dimer based structure, respectively. All of the three compounds show photoluminescence, with the internal quantum yield (IQY) as high as 88.2% for 1. This work provides evidence that for this type of hybrid materials, the structure of the inorganic module could be determined by the selection of the organic ligands and that the substituted group on the organic ligands can influence the luminescence efficiency of the hybrid structures.
研究领域:
无机化学
·
材料化学
·
配位化学
·
光物理
·
功能材料
✓ 已验证
DOI
高影响因子
Advanced Optical Materials
·
2022
·Vol. 10
·期 15
·2200605
·
IF 10.05
Shaofan Fang,Bo Zhou,Huixia Li,Hanlin Hu,Haizhe Zhong,Henan Li,Yumeng Shi
Metal halide perovskites are promising optoelectronic materials due to their unique luminescent properties. However, their practical application is limited by their poor chemical stability, especially in humid environments. Moisture can cause phase changes or chemical decomposition, resulting in significant fluorescence quenching. In this study, a copper-based organic–inorganic hybrid metal halide (t-BA) 3 Cu 6 I 9 is synthesized (t-BA + is the tert-butyl-ammonium ion (C(CH 3 ) 3 NH 3 + )). This material exhibits water-induced luminescence, and its chemical stability in humid environments is being investigated. Tetragonal t-BA 3 Cu 6 I 9 is not luminescent, but it reacts quickly with water in the air. The resultant (t-BA) 2 Cu 2 I 4 ·H 2 O has a broad green emission peak at 520 nm, high photoluminescence quantum yield of 59.4%. Remarkably, (t-BA) 2 Cu 2 I 4 ·H 2 O is converted back to t-BA 3 Cu 6 I 9 at temperatures above 40 °C. This phase conversion is highly repeatable, and the luminescent intensity can be fully recovered after 50 transformation cycles. The mechanism of luminescence is investigated through temperature-dependent photoluminescence spectra and theoretical calculation, which suggests that (t-BA) 2 Cu 2 I 4 ·H 2 O has a more localized charge distribution and sufficient polyhedral distortion, resulting in a bright and efficient emission from self-trapped excitons. This is the first report of water-induced luminescence in copper-based metal halides, and it paves the way for stable luminescent materials that are responsive to humidity.
研究领域:
材料化学
·
光物理学
·
无机化学
·
功能材料
·
发光材料
✓ 已验证
DOI
高影响因子
RSC Advances
·
2017
·Vol. 7
·期 6
·3136-3144
·
IF 3.108
Huan Liu,Zi-en Fu,Fei Song,Qingquan Liu,Lijuan Chen
Using a hydrolysis condensation of triethoxysilane to prepare a synthetic benzoxazine-bridged bis(triethoxysilane) compound (BS), a series of benzoxazine-bridged polysilsesquioxanes precursors were prepared with different degrees of hydrolysis condensation. Ring-opening thermal homopolymerization of the benzoxazine rings in these precursors was employed to obtain several organic–inorganic hybrid materials. The chemical structures of these synthetic compounds were characterized by Fourier transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (1H, 13C, 29Si NMR) spectroscopy and elemental analysis (EA). For the morphologies of these hybrid materials, different features of the lamellar structures were explored by transmission electron microscopy (TEM). From the results of energy dispersive X-ray spectroscopy (EDS), these lamellar structures were found to be comprised of carbon-rich (C-rich) and silicon-rich (Si-rich) layers. From a view-point of the structure–property relationships, the optical (photoluminescence (PL)), thermal (glass transition temperature (Tg) and thermogravimetric analysis (TGA)) properties were well characterized and discussed. Based on these results, we proposed that this chemically controllable method has potential as an effective approach used to prepare organic–inorganic hybrid materials with controllable morphology.
研究领域:
材料科学
·
高分子化学
·
杂化材料
·
功能材料
·
热分析
·
光谱学
✓ 已验证
DOI
高影响因子
PHOTOCHEMICAL & PHOTOBIOLOGICAL SCIENCES
·
2015
·Vol. 14
·期 2
·358-365
·
IF 2.267
Chen Lei,Yan Bing
Some multi-component hybrids based on zeolite L/A are prepared. Firstly, zeolite A/L is loaded with lanthanide complexes (Eu-DBM or Tb-AA (acetylacetone = AA, dibenzoylmethane = DBM)) into its channels. Secondly, 3-methacryloyloxypropyltrimethoxysilane (γ-MPS) is used to covalently graft onto the surface of functionalized zeolite A/L (Si-[ZA/L ⊃ Eu-DBM(Tb-AA)]). Thirdly, lanthanide ions (Eu 3+ /Tb 3+ ) are coordinated to the functionalized zeolite A/L and ligands (phen(1,10-phenanthroline) or bipy (2,2′-bipyridyl)) are introduced by a ship-in-bottle method. The inside-outside double modifications of ZA/L with lanthanide complexes afford the final hybrids and these are characterized by means of XRD, FT-IR, UV-vis DRS, SEM and luminescence spectroscopy, some of which display white or near-white light emission. Furthermore, selected above-mentioned hybrids are incorporated into PEMA/PMMA (poly ethyl methylacryate/poly methyl methacrylate) hosts to prepare luminescent polymer films. These results provide abundant data that these hybrid materials can be expected to have potential application in various practical fields.
研究领域:
材料科学
·
无机化学
·
光致发光
·
杂化材料
·
聚合物纳米复合材料
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）