Nanoporous Mixed-Phase In2O3 Nanoparticle Homojunctions for Formaldehyde Sensing
Designing a reliable sensor for indoor formaldehyde (HCHO) with high sensitivity and selectivity is crucial for environmental and health protection. This study reported HCHO sensors based on a nanoporous mixed-phase In2O3 nanoparticle. A combined cubic and orthorhombic phase In(OH)3/InOOH [c-In(OH)3/o-InOOH] precursor, synthesized through a facile solvothermal route at different temperatures, was annealed to prepare the In2O3 nanoparticle homojunction. The obtained In2O3, calcined at 350 °C, exhibited a porous structure and a large specific surface area of 81.46 cm3·g–1, facilitating more number of active sites’ exposure for HCHO-sensing reactions. Results showed that the In2O3 calcined at 350 °C exhibited the best HCHO-sensing performances at 120 °C with a large response value (330–50 ppm), good selectivity, and a short response time (12 s). Additionally, its detection limit could reach 11 ppb. This HCHO gas sensing behavior was owing to the mixed-phase homojunction structure formed between cubic and rhombohedral In2O3, the large specific surface area, and the porous structure with abundant oxygen vacancies. This study indicated that the nanoporous mixed-phase In2O3 nanoparticles could be the potential candidates for rapidly detecting HCHO at low concentration levels under low power consumption.
危险品化学品经营许可证（带存储）