An experimental study of single carbon dioxide (CO 2 ) bubbles ascending in aqueous solutions of carboxymethyl cellulose (CMC) is performed as a means to obtain further understanding of the rising behavior and mass transfer of soluble bubbles in shear-thinning non-Newtonian fluids. High-speed photography and digital image processing technique are employed to quantify the characteristic parameters of the bubble rising process. The rising behavior of single CO 2 bubbles in a Newtonian fluid (tap water) is measured as a reference. It has been found that the rheology of the liquid phase significantly influenced the rising behavior of the bubbles. In CMC aqueous solutions, CO 2 bubbles mostly followed a straight rising path characterized by increasing aspect ratio and decreasing vertical velocity. Increase in initial bubble size led to bubble deformation in less concentrated CMC aqueous solutions which resulted in an irregular rising path. The evolution of bubble equivalent diameter can be mainly divided into two stages: a fast reduction stage followed by a slow one. Meanwhile, the variation of liquid-side mass transfer coefficient k L of CO 2 bubbles in tap water and CMC aqueous solution with different weight percentages is discussed. The mobility of gas-liquid interface is considered to have significant impact on gas-liquid mass transfer. A dimensionless correlation considering the rheology of the liquid phase is proposed to describe the evolution of the motion and deformation of single soluble CO 2 bubbles in infinite stagnant shear-thinning non-Newtonian liquids.
The preparation of high specific-capacity pseudocapacitive transition-metal-oxide/hydroxide (TMH) materials into transparent micro-structure electrodes is a great challenge and has become the bottleneck restricting the performance of transparent flexible supercapacitors . Beyond that, extending the operating voltage window is an urgent need for improving energy density . Here, Co(OH) 2 nanosheets and amorphous FeOOH nanowires were prepared into transparent films through a simple and scalable bio-inspired method at the air-solution interface. Both nanostructures are enwrapped in graphene shells (Co@Gr-TFandFe@Gr-TF) for use as transparent asymmetric pseudocapacitive electrodes. The unique encapsulation structures (1) provide pseudocapacitive electrode materials, especially an amorphous FeOOH structure cathode, (2) build up rapid three-dimensional electron and ion transport pathways together with the underlying ITO layer, (3) alleviate the exfoliation and dissolution of the active materials into electrolyte, and (4) extend the potential window of the FeOOH cathode from −0.8 ∼ 0 V to −1.2 ∼ 0 V with minimal cycling stability degradation. The asymmetric transparent and flexible supercapacitor based on Co@Gr-TF//Fe@Gr-TF operated at 1.8 V exhibits good transparency (50.5% at 550 nm), high specific capacitance (25.5 mF cm −2 , one order higher than the maximum value reported for FFT-GP), and high energy density (1.04 mWh cm −3 , comparable to that of nontransparent devices) as well as a long cycle life (10 000 cycles) with high-capacity retention (83.5%).