Xiang Nie,Guo Li,Zhao Jiang,Wei Li,Ting Ouyang,Jianfeng Wang
Exfoliation of two-dimensional boron nitride nanosheets (BNNSs) from parent bulk material has been receiving intensive attention because of its fascinating physical properties. Liquid exfoliation is a simple, scalable approach to produce single-layer or few-layer BNNS. In this paper, water/propanol co-solvent exfoliation of bulk boron nitride under the assistance of sonication was investigated in detail. Special attention was paid on the effect of raw bulk boron nitride size and co-solvent composition. The results show that sonication of small-size hexagonal boron nitride tends to generate large nanosheets, due to a predominant solvent wedge effect. In addition, it is found that the composition of water/propanol co-solvent has an important effect on exfoliation efficiency. Interestingly, although two isomers of 1-propanol (NPA) and 2-propanol (IPA) have the same molecular weight and similar surface tension, their aqueous solutions allow the formation of boron nitride nanosheets dispersion with markedly different concentrations. It is proposed that due to their spatial configuration difference, NPA with its longer molecular chain and fewer hydrophobic methyl group tends to form dynamic water-NPA clusters with larger size than water-IPA clusters. The hydrodynamic radius of the co-solvent “clusters” was calculated to be 0.72 nm for water/NPA system and 0.44 nm for water/IPA system at their maximum, respectively. Their size changes, represented by two curves, indicate a strong “cluster size” effect on exfoliation efficiency. Our work provides an insight into co-solvent exfoliation of hexagonal boron nitride and emphasizes the importance of co-solvent cluster size in exfoliation efficiency.Keywords:liquid phase exfoliation;boron nitride nanosheets;co-solvent cluster;size effect
Lingzhi Zhang,Yinghao Wang,Fang Zheng,Di Zhu,Yongmei Liang,Quan Shi
The collision cross-section (CCS) values of ions determined by ion mobility-mass spectrometry (IM-MS) can be used to deduce the shape and size of the ions. For each compound, as well as its isomer or tautomer, a unique arrival time peak was obtained in extracted ion mobility (EIM) spectra, which corresponded to a specific CCS value. However, the generation of solvated ions by electrospray ionization (ESI) increases the number of mobility peaks, which makes the EIM spectra difficult to interpret. In this study, solvent clusters formed by acetonitrile and methanol around 1,8-naphthalic anhydride (1,8-NA) cations ([C12H6O3 + H]+1,8-NA) were investigated using trapped ion mobility spectrometry-time-of-flight mass spectrometry (TIMS-TOF MS). The effects of infusion flow rate, nebulizer gas pressure, drying gas rate, and drying gas temperature on the formation of solvent clusters from acetonitrile and methanolic solution were systematically studied. The formation of solvent clusters was observed with infusion flow rates increased, which was manifested by the larger experimental CCS values of [C12H6O3 + H]+1,8-NA. Acetonitrile tended to form solvent clusters around ions more readily than methanol. These solvent clusters were stable enough to be detected by TIMS, but they cannot survive under ion activation conditions of mass spectrometry (MS). Increasing the nebulizer gas pressure seems to be a better way to eliminate the formation of solvent clusters in TIMS-TOF MS and give a “cleaner” EIM spectra. The current research demonstrates that more attention should be paid to the solvent effect on CCS values and their interpretation.
危险品化学品经营许可证（带存储）