Effects of Solid Precipitation and Surface Corrosion on the Adhesion Strengths of Sintered Hydrate Deposits on Pipe Walls
A hydrate directly growing and sintering on a pipe wall is an important hydrate deposition case that has been relatively unexplored. In the present study, the adhesion strengths of a sintered cyclopentane (CyC5) hydrate deposit under different solid precipitation and surface corrosion conditions were measured and discussed. It was found that the hydrate adhesion strengths increased by 1.2–1.5× when the soaking time of the carbon steel substrate in a 5 wt % NaCl solution increased from 24 to 72 h, which reduced the water wetting angle from 112 ± 3.5° to 94 ± 3.3°. The wax coating reduced the strength of CyC5 hydrate adhesion by up to nearly 20-fold by reversing the substrate wettability and affecting the hydrate morphology. The measurements performed on scales indicate that calcium carbonate scales strengthen the adhesion strength because of the decrease in the water wetting angle. In addition, honeycomb holes on the surface reduce amplification. Furthermore, settling quartz sand on the wall reduced the adhesion strengths by decreasing the effective sintering area of the hydrate on the underlying base. Finer sand and higher concentrations led to lower strengths. On the basis of the verified linear correlation between the hydrate adhesion strength and the adhesion work of droplets on different substrates and the influence of water conversion during deposition, both an equation and a key constant parameter were obtained to predict the sintered hydrate deposit adhesion strengths on substrates.
危险品化学品经营许可证（带存储）