SOLID STATE IONICS
·
2014
·
IF 2.112
Jing Yang,Zhen Huang,Bingxin Huang,Jing Zhou,Xiaoxiong Xu
NASICON-type structure lithium ion conductors have been considered as promising solid electrolytes due to its very high Li + -ion conductivity and chemical stability. In this paper, NASICON-type structured Li 1.5 Al 0.5 Ge 1.5 (PO 4 ) 3 (LAGP) glass–ceramics are prepared from crystallization of glass powders, which are obtained by a simple melt-quench method. NH 4 H 2 PO 4 , H 3 PO 4 , P 2 O 5 and H 3 PO 4 &Al(PO 3 ) 3 are used as phosphorus sources, respectively. The obtained LAGP glass–ceramics are systematically characterized with X-ray diffraction, field emission scanning electron microscopy , differential scanning calorimetry and AC impedance spectroscopy . The different impurities are formed depending on the phosphorus sources, which further influence the microstructure. As a result, the lithium ion conductivity is significantly affected by the phosphorus sources. The highest conductivity of 5.21 × 10 − 4 S·cm − 1 is obtained when H 3 PO 4 is used as the phosphorus source under optimum conditions.
研究领域:
材料科学
·
固态离子学
·
无机非金属材料
·
能源材料
·
电化学
✓ 已验证
DOI
高影响因子
CERAMICS INTERNATIONAL
·
2020
·Vol. 46
·期 8
·10917-10924
·
IF 3.83
Li Yang,Qiushi Dai,Lei Liu,Dingsheng Shao,Kaili Luo,Sidra Jamil,Hong Liu,Zhigao Luo,Baobao Chang,Xianyou Wang
Solid electrolytes could address the increasingly urgent safety and energy density concerns of lithium-ion batteries. Among several kinds of solid electrolytes, Ta-doped Li 7 La 3 Zr 2 O 12 (Ta-LLZO) became a research hotspot because of its high Li-ion conductivity and chemical stability against Li-metal and air. However, the preparation of high quality LLZO ceramic electrolyte via conventional air ambient sintering method is still a big challenge due to the serious “Li-loss” and abnormal grain growth phenomenon during the long-time high-temperature sintering process . Herein, a new rapid ultra-high-temperature air ambient sintering method without mother powder (MP) is put forward for the preparation of high quality Ta-LLZO ceramic electrolyte. The rapid sintering strategy can effectively restrain “Li-loss”. Furthermore, it is demonstrated that the none-mother-powder method is superior to traditional mother-powder method. Ta-LLZO ceramics sintered without MP via this rapid sintering method own small grain size, tight grain boundary, dense microstructure and high conductivity. Specifically, the Ta-LLZO ceramic sintered at 1360 °C for 10 min without MP exhibits high conductivity (8.5 × 10 −4 S cm −1 at 25 °C) and high relative density (97%), which equate those made by hot pressing sintering method. Without MP, the sintering process can avoid a lot of material waste and simplify the operation process. Moreover, the rapid sintering process can sharply shorten sintering time and reduce energy consumption. Therefore, this low-cost high-efficient sintering strategy can be effectively used in the large-scale production of high-quality Ta-LLZO ceramic electrolyte.
研究领域:
材料科学
·
固态离子学
·
能源材料
·
电化学
·
无机非金属材料
·
电池技术
✓ 已验证
DOI
高影响因子
MACROMOLECULAR RAPID COMMUNICATIONS
·
2021
·Vol. 42
·期 22
·2100457
·
IF 5.734
Xiaobin Li,Ending Zhang,Jun Shi,Xiaoyan Xiong,Jiaming Lin,Qiang Zhang,Xiaohua Cui,Liqin Tan,Kun Wu
In the past two decades, ionic conductive hydrogel has attracted tremendous research interests for their intrinsic characteristics in the field of flexible sensor. However, synchronous achievement of high mechanical strength, satisfied ionic conductivity, and broad adhesion to various substrates is still a challenge. Herein, a novel zwitterionic composite hydrogel that displayed excited strechability (up to 900%), satisfied strength (about 30 kPa), high ionic conductivity (1.2 mS cm −1 ), and adhesion to polar and nonpolar materials is fabricated though the combination of waterborne polyurethanes (PU) and poly(sulfobetaine zwitterion- co -acrylamide) (SAm). Especially, this facile strategy demonstrates that PU has a synergistic effect on enhancing mechanical strength and ionic conductivity for ionic conductive hydrogel. Moreover, the hydrogel-based strain/stress sensor shows high sensitivity, wide sensing range, great stability, and accuracy for human body movements detecting and voice recognition. This novel ionic conductive hydrogel has promoted the development of wearable devices.
研究领域:
生物材料
·
高分子科学
·
柔性电子学
·
生物医学工程
·
传感器技术
✓ 已验证
DOI
高影响因子
Journal of Materials Chemistry A
·
2020
·Vol. 8
·期 40
·21265-21272
·
IF 11.301
Lei Gao,Hao Zhang,Yuechao Wang,Shuai Li,Ruo Zhao,Yonggang Wang,Song Gao,Lunhua He,Hai-Feng Song,Ruqiang Zou,Yusheng Zhao
Sodium-rich antiperovskite (NaRAP) ionic conductors have been considered promising inorganic electrolytes for all-solid-state sodium batteries due to their low fabrication cost, high sodium ionic conductivity and good structural tolerance. The high structural flexibility of NaRAPs allows variety of chemical substitutions to improve conductivity; in particular, the substitution of the anion cluster has effectively proved promoting Na+ migration, both experimentally and theoretically. Herein, we report an unexpected boost in Na+ ionic conductivity that climbs to 0.37 mS cm−1 at 485 K by introducing NO2− groups in the antiperovskite Na3ONO2 system. Its mechanism was fully investigated by neutron powder diffraction and DFT calculations, proving that the NO2− group on the lattice center, can utilize its terminal O2− anion to facilitate the Na+ migration via the Na–O interaction, when thermally excited at 485 K. The detailed migration path is also discussed by both maximum entropy method (MEM) and DFT calculations.
研究领域:
材料科学
·
固态离子学
·
无机化学
·
能源材料
·
计算材料学
✓ 已验证
DOI
高影响因子
JOURNAL OF ALLOYS AND COMPOUNDS
·
2023
·
IF 6.2
Yanhua Zhang,Yuhang Mei,Xinglong Gao,Yumei Xiao,Zijun Tang,Xing Xiang,Jiadong Deng
The lithium dendrite problem of Li 7 La 3 Zr 1.4 Ta 0.6 O 12 (LLZTO) solid electrolyte restricts the practical application and development of all-solid-state lithium batteries (ASSLBs). Herein, a LiPON interlayer with Li + conductive and electron non-conductive dynamic properties is constructed at the Li/LLZTO interface. Results show that the electronic conductivity of solid electrolyte after LiPON modification decreased by nearly three orders of magnitude, indicating that it has good ability to hinder electron conduction . The interlayer enhances the wettability between the Li metal anode and LLZTO, resulting in a decrease of battery resistance from 3400 Ω to 700 Ω. The critical current density of the ASSLBs increase from 0.1 mA cm −2 to 1.2 mA cm −2 at room temperature, and the battery cycle number increase from 31 h to over 1000 h. XPS deep etching results show that the LiPON/LLZTO interface has good electrochemical stability. The Kelvin probe force microscope displays a sharp increase in potential within the LiPON interlayer, indicating its successful hindrance of electron conduction to the solid electrolyte. The effective inhibition of lithium dendrites growth is due to LiPON can promote the Li + transmission from LLZTO solid electrolyte to Li anode, and also hinder the electron conduction to LLZTO to form lithium dendrites.
研究领域:
材料科学
·
电化学
·
能源存储
·
固态电池
·
界面工程
✓ 已验证
DOI
高影响因子
MATERIALS CHEMISTRY AND PHYSICS
·
2021
·
IF 4.094
Zhongxu Li,Shengzhao Zhang,Zhao Jiang,Dan Cai,Changdong Gu,Jiangping Tu
A novel cheap eutectogel (ETG) membrane based on the deep eutectic solvent (DES) immobilized poly (vinylidene fluoride-hexafluoro propylene) (PVDF-HFP) is proposed as a solid electrolyte for safe lithium metal batteries in this study. The composition of DES is optimized, which is prepared by mixing the N-methylacetamide (NMAC) and the lithium bis [(trifluoromethyl)sulfonyl]imid (LiTFSI) with a molar ratio of 4:1. The eutectogel is formed by incorporating 70 wt% DES into the PVDF-HFP, which is non-flammable and shows excellent mechanical properties. This ETG membrane electrolyte with a thickness about 25 μm possess a high ionic conductivity (3.05 × 10 −4 S cm −1 ) at room temperature and a wide electrochemical stability window (~5 V). The Li//ETG//LiFePO 4 full cells deliver an acceptable discharge capacity of ~133.9 mAh g −1 at 0.1C and room temperature after 100 charge-discharge cycles. The ETG membrane electrolyte can also endow the Li//ETG//LiFePO 4 pouch cell with flexibility and withstanding abuse operations, like nail penetration and cutting. We expect that the flexible and non-flammable eutectogel membrane will have implications for the use of DES based ionic liquids in the synthesis of advanced solid-state electrolytes for safer lithium batteries .
研究领域:
材料科学
·
电化学
·
能源存储
·
高分子物理
·
电池技术
✓ 已验证
DOI
高影响因子
CARBOHYDRATE POLYMERS
·
2018
·
IF 5.158
Ningxiao Yuan,Lu Xu,Bo Xu,Jianhao Zhao,Jianhua Rong
Chitosan derivative-based self-healable hydrogels with enhanced mechanical properties are reported, which were prepared by polymerization of acrylic acid (AAc) in 2-hydroxypropyltrimethyl ammonium chloride chitosan (HACC) solution. The PAAc/HACC hydrogels exhibit tensile fracture stress as high as 3.31 MPa and a Young's modulus of 2.53 MPa. They can maintain their original shape after 30 repeated compression cycles under various strain conditions, with a compression stress of more than 60 MPa at 99% strain. The damaged PAAc/HACC hydrogels can heal together in the presence of a NaCl salt solution with a self-healing efficiency of up to 61%. In addition, the PAAc/HACC hydrogels have high ionic conductivity and can serve as electrolytes for supercapacitors. The analysis suggests that all these good properties of the PAAc/HACC hydrogels mainly result from their high-density dynamic ionic interactions structure.
研究领域:
高分子材料科学
·
生物医学工程
·
功能材料
·
组织工程
·
药物递送系统
·
再生医学
·
电化学器件
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）