Zujiang Pan,Cuo Jian,Zaihua Peng,Xinzhuang Fu,Rui He,Tong Yue,Wei Sun
The Yulong copper deposit in Tibet is a typical porphyry copper deposit, with about 30 million tons of copper oxide ore in the surface layer. However, more than 40% of the copper resources are in a combination state, resulting in an extraction efficiency of only 50% for copper via the hydrometallurgical process. In this study, the process mineralogy of the combined copper oxide ore was systematically investigated and a calcium fluoride-enhanced leaching process is proposed to increase the leaching efficiency of the combined copper ore. The process mineralogy of the combined copper oxide ore was analyzed using various testing techniques, including chemical analysis, X-ray diffraction, and a process mineralogy parameter testing system (Mineral Liberation Analysis). The results revealed that limonite accounted for 86.12% of the sample, and 63.51% of the copper resource existed in the form of combined copper oxide in limonite. However, it is difficult for the uniformly distributed combined copper oxide in limonite to sufficiently make contact with sulfuric acid, which is the leaching agent, resulting in low copper leaching efficiency. The enhanced leaching behavior of the combined copper oxide ores was also investigated, thereby determining effective and economical enhanced leaching conditions. Under optimal conditions, at a grinding fineness ratio of −0.074 mm (accounting for 85%), liquid-solid ratio of 4:1, sulfuric acid concentration of 50 g/L, temperature of 30 °C, CaF2dosage of 1% of the ore mass, and leaching time of 4 h, the copper leaching efficiency increased to 60.57%, which was 7.34% higher than that of atmospheric pressure leaching. Finally, the enhanced leaching slag was analyzed using an electron probe microanalyzer. It indicated that fluorine ions can erode the combined copper oxide ore and facilitate the diffusion of hydrogen ions inside the limonite, thereby achieving a strengthening effect.
Liuting Li,Jiufeng Dong,Renchao Hu,Xianqiang Chen,Yujuan Niu,Hong Wang
In advanced electronics and electrical power systems, polymer dielectric capacitors are favored for their high power density and great reliability. However, the low energy density at high temperatures constrains their use in emerging applications. To address this vital issue, herein, a novel calcium fluoride (CaF 2 ) nanoparticle with a wide bandgap (∼12.1 eV) and moderate permittivity (∼10.0) is prepared by a simple direct precipitation method and then introduced into the polyimide (PI) matrix. The incorporation of the CaF 2 nanoparticles increases the permittivity and reduces conduction loss simultaneously. Consequently, at 150 ℃, the PI film with 3 vol% CaF 2 exhibits enhanced discharged energy density and breakdown field of 2.68 J cm −3 and 455.4 MV m −1 , respectively. Besides, the composite shows a higher power density of 0.36 MW cm −3 and a faster discharge speed of 2.09 μs at 150 ℃ than that 2.93 μs of biaxially oriented polypropylene (BOPP) measured at 85 ℃. Notably, CaF 2 nanofiller, as a deep trap, captures injected charges and alleviates the local electric distortion, as revealed by finite element simulation and thermally stimulated discharge current (TSDC) measurement. This work proposes a novel fluoride nanofiller to rationalize the energy storage improvement of high-temperature composites with potential wide application.