Fabrication, sintering behavior, and strength of tritium breeding ceramic pebbles with Pb addition
Lithium ceramics are regarded as potential candidates for tritium breeding in fusion reactors. Lead (Pb) was added to the ceramic to improve the strength and tritium release properties. The Li 2 TiO 3 -0.5Li 4 SiO 4 –Pb ceramic powders with the Pb contents of 5 wt% and 20 wt% were prepared by microwave-induced solution combustion synthesis . It was confirmed that the Pb was in the form of the Li 2 PbO 3 phase in the powders. The Li 2 TiO 3 , Li 4 SiO 4 , and Li 2 PbO 3 crystallites were composited at nanoscale level, which was confirmed by the transmission electron microscopy (TEM). During high-temperature sintering, the Li 2 PbO 3 was transformed into PbO, which facilitated the densification process at low temperatures. The chemical state in the sintered body was characterized by X-ray photoelectron spectroscopy (XPS) with 3 keV Ar + sputtering. The binding energies for Pb were 137.2 and 142.2 eV. There was almost no change in peak position during Ar + sputtering, showing that Pb was firmly adherent with oxygen atoms. Besides, the as-synthesized powders were used for the pebble fabrication. The average crush load of Li 2 TiO 3 -0.5Li 4 SiO 4 –20%Pb pebbles sintered at 1223 K was 124 N, which was much higher than that without Pb addition. It was proved that the crush load increased almost linearly with the increase in the size of the pebbles. Thus, the bending strength of the sintered ceramic body was used to evaluate the mechanical properties. Further, the grain growth kinetics was studied. It was confirmed that the Pb addition reduced the activation energy of grain growth, which realized the densification of the ceramic pebbles at low temperatures.
危险品化学品经营许可证（带存储）