Preparation and friction properties of SiC-Al2O3/2A50 co-continuous composites
This study investigated the preparation of SiC porous ceramics using an organic foam impregnation-high temperature sintering process. To address the poor wettability of SiC ceramics when used as the reinforcement phase, the surface of SiC porous ceramics was modified with Al 2 O 3 . SiC-Al 2 O 3 /2A50 co-continuous composites were then fabricated by infiltrating 2A50 aluminum alloy into the SiC-Al 2 O 3 porous ceramics under pressure. Microstructural observations, along with friction, wear performance, and thermal stability test, demonstrated that Al 2 O 3 surface modification significantly enhances the friction and wear performance as well as the thermal stability of the co-continuous composites. The prepared SiC-Al 2 O 3 /2A50 co-continuous composite exhibited excellent wear resistance, good thermal stability and stable bonding at heterogeneous interfaces. Compared to 38CrSi steel, the SiC-Al 2 O 3 /2A50 co-continuous composite not only offers the advantage of reduced weight but also shows a significantly lower wear rate of 9.3 × 10 −5 mm 3 /N·min under a 50 N load. These findings suggest that the SiC-Al 2 O 3 /2A50 co-continuous composite has the potential to replace 38CrSi steel as a wear-resistant material.
危险品化学品经营许可证（带存储）