Hailin Pan,Jie Wang,Zhi Chen,Ziqi Su,Zheng Tang,Zaifei Ma
Developing transparent conductors to replace indium tin oxide (ITO) is a critical objective in the field of organic optoelectronics. Non-atomically doped (NAD) ZnO thin films, while currently exhibiting limited conductivity, are highly promising candidates due to their unique advantages, such as having complete transparency in both the visible and near-infrared spectral regions, solution processability, and the desired surface electronic properties. In this work, the impact of surface modification by insulating polymers on the ultraviolet-enhanced conductivity of NAD-ZnO films is investigated. It was found that polymer modifiers that are rich in amino and hydroxyl groups are effective at increasing the concentration of oxygen vacancies and the conductivity of NAD-ZnO films. The highest conductivity of over 1000 S cm–1, which is more than twice as high as the previous record for NAD-ZnO films, is achieved using polyethylenimine ethoxylated (PEIE) to modify NAD-ZnO films. Subsequently, the replacement of ITO in organic photovoltaic devices by a ZnO/PEIE electrode is realized. The ZnO/PEIE-based OPV devices that were created exhibit performances comparable to those of ITO-based devices under simulated solar illumination and performances better than those achieved with ITO-based devices under simulated indoor illumination. These results make NAD-ZnO a promising candidate for the widespread replacement of ITO in optoelectronic devices.
Metal mesh is a significant candidate of flexible transparent electrodes to substitute the current state-of-the-art material indium tin oxide (ITO) for future flexible electronics. However, there remains a challenge to fabricate metal mesh with order patterns by a bottom-up approach. In this work, high-quality Cu mesh transparent electrodes with ordered pore arrays are prepared by using breath-figure polymer films as template. The optimal Cu mesh films present a sheet resistance of 28.7 Ω·sq–1 at a transparency of 83.5%. The work function of Cu mesh electrode is tuned from 4.6 to 5.1 eV by Ag deposition and the following short-time UV–ozone treatment, matching well with the PEDOT:PSS (5.2 eV) hole extraction layer. The modified Cu mesh electrodes show remarkable potential as a substitute of ITO/PET in the flexible OPV and OLED devices. The OPV cells constructed on our Cu mesh electrodes present a similar power conversion efficiency of 2.04% as those on ITO/PET electrodes. The flexible OLED prototype devices can achieve a brightness of 10 000 cd at an operation voltage of 8 V.
危险品化学品经营许可证（带存储）