文献检索

查找使用阿拉丁产品的科研文献

检索与阿拉丁产品相关的同行评审论文、DOI、PubMed 编号、期刊、作者、CAS 号及研究领域。

科研影响力快照

与阿拉丁产品相关的已发表科研成果

在搜索之前,这些指标可帮助访客快速了解产品关联科研的规模与质量。

346,364+ SCI 论文 与阿拉丁产品引用相关
2,295,288.15 总影响因子 匹配文献记录中影响因子的总和
81.20 最高期刊影响因子 匹配期刊中的最高 IF
6.63 平均期刊影响因子 匹配文献的平均 IF

参考指标 指标基于阿拉丁文献引用数据库及期刊影响因子记录。文献关联仅供科研参考,请以原始文献为准。

热门产品

视图 列表 网格

6 项

设置提升方向
LED光照
Coatings · 2022 ·Vol. 12 ·期 5 ·585 · IF 3.236

N-TiO2-Coated SiC Foam for the Treatment of Dyeing Wastewater under Blue Light LED Irradiation

Wen Sun,Xuankun Li,Jingtao Zou,Han Guo

TiO2is widely used for the photocatalytic degradation of organic pollutants in wastewater, but the practical applications of the photocatalyst are limited due to its poor visible light absorption and low recovery rate. In this study, high production of nitrogen-doped TiO2was achieved by a hydrolysis precipitation method; the obtained N-TiO2had a small crystallite size and good dispersibility. The effect of calcining temperature on the photocatalytic performance of N-TiO2was evaluated through the degradation of methylene blue (MB) in a blue light LED irradiation cylinder, it was found the N-TiO2calcined at 400 °C showed the best photocatalytic activity. Then the N-TiO2was immobilized on SiC ceramic foam by dip-coating with PVA as the binder. The prepared N-TiO2/SiC foam showed excellent photocatalytic activity under blue light LED irradiation; as high as 96.3% of MB was degraded at optimum conditions. After five cycles of MB photodegradation, the photocatalytic activity of N-TiO2/SiC foam only changed slightly, which makes it a promising photocatalytic material for wastewater treatment.Keywords:nitrogen-doped TiO2;SiC foam;LED irradiation;photodegradation;methylene blue

CAS / MDL: 9002-89-5
研究领域: 环境科学 · 材料科学
✓ 已验证 产品关联 DOI 高影响因子
查看原文 查看 PubMed
CERAMICS INTERNATIONAL · 2024 · IF 5.1

Antimicrobial studies of visible light-responsive nanoflower spheres Bi2WO6/ZnO

Luyin Zhao,Jingmei Li,Jiayun Shao,Ling Zhang,Yuhao Ji,Xiulong Li,Dianmin Ju

The contamination of water resources in recent years has resulted in the dissemination of harmful bacteria via water sources, posing a significant threat to the safety and well-being of humans, animals, and plants. Consequently, there is a growing concern over the health and sanitation of water resources. Photocatalysis, a novel and very effective antibacterial method, has gained significant attention in the area of antibacterial research. Bismuth nitrate pentahydrate and sodium tungstate dihydrate were used in a straightforward hydrothermal process to create nanoflower spheres Bi 2 WO 6 /ZnO photocatalytic composites in molar ratios of 1:1, 1:2, 1:3, and 1:4. The first-ever demonstration of the photocatalytic broad-spectrum antibacterial activity of porous nanoflower spheres Bi 2 WO 6 /ZnO composites was shown. The samples were analyzed using X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), Fourier-transform infrared spectroscopy (FT-IR), and ultraviolet–visible spectroscopy (UV–vis). The antibacterial activity was evaluated using the dilution coated plate technique, with LED light irradiation. The findings indicate that the Bi 2 WO 6 /ZnO composite has a much superior antibacterial activity against both bacteria and fungus compared to individual Bi 2 WO 6 and ZnO. When exposed to LED lighting with an intensity of 35 W, the Bi 2 WO 6 /ZnO nanoparticles in a 1:2 ratio at a concentration of 1000 mg/L demonstrated complete antibacterial effectiveness against Escherichia coli, Staphylococcus aureus, Pseudomonas aeruginosa, and Bacillus subtilis within 30 min. Similarly, the nanoparticles achieved 100 % antibacterial efficiency against Candida albicans within 90 min. The antibacterial efficacy of 1000 mg/L 1:2 Bi 2 WO 6 /ZnO nanoparticles against Escherichia coli and Staphylococcus aureus was found to be 100 % within 5 min under natural lighting conditions. The findings indicate that Bi 2 WO 6 /ZnO nanoparticles have excellent photocatalytic broad-spectrum antibacterial efficacy.

研究领域: 环境科学 · 微生物学 · 材料科学
✓ 已验证 产品关联 DOI 高影响因子
查看原文 查看 PubMed
RSC Advances · 2024 ·Vol. 14 ·期 47 ·34606-34610 · IF 3.9

Synthesis of MoS2/MoO3 nano-heterojunction towards enhanced photocatalytic activity under LED light irradiation via in situ oxidation sintering

Jianfeng Qiu,Yanping Liu,Minxian Cao,Luqi Xie,Yongkun Liu,Hongwen Li,Junqiang Lu,Qifeng Liang,Jiaqi Pan,Chaorong Li

The MoS2/MoO3 nano-heterojunction photocatalyst was synthesized via the in situ oxidation sintering method. The properties of the samples were characterized by XRD, SEM, EDX, TEM, UV-vis, PL, FT-IR, BET and electrochemical techniques. The MoS2/MoO3 nano-heterojunction (MS-400) exhibited significantly better photocatalytic activity toward Rhodamine B degradation (0.42634 h−1) than monomer MoS2 (∼8.0-folds) and MoO3 (∼25.6-folds). This is mainly attributed to the MoS2/MoO3 heterojunction interface having an appropriate potential gradient that can promote the interface carrier transportation/separation to optimize the carrier efficiency and increase the solar absorption and specific surface areas/active sites via microstructures.

CAS / MDL: 1317-33-5
研究领域: 材料科学 · 环境科学
✓ 已验证 产品关联 DOI PubMed 高影响因子
查看原文 查看 PubMed
APPLIED CATALYSIS B-ENVIRONMENTAL · 2025 · IF 21.1

Efficient photothermal catalytic oxidation of 5-hydroxymethylfurfural using stable 4-OH-TEMPO radical

Bei Jiang,Mengya Xu,Ling Zhang,Wenjing Wang,Xin Qin,Shenyan Xu,Chunyu Che,Chuanqi Zhang,Wenzhong Wang

Open-shell organic radicals, characterized by their unique spin states, typically exhibit exceptional photothermal conversion efficiency. However, the development of open-shell organic radical materials with stability and high photothermal properties remains a challenge. Among these radicals, the stable and commercialized 4-OH-TEMPO radical molecule has garnered considerable attention in various organic synthesis reactions owing to its unique redox advantages, but it shows less application comparing with the other open-shell organic radicals in photo-thermal conversion. In this study, 4-OH-TEMPO exhibits favorable photothermal properties upon combination with Cu 2 + , thus it is capable of enhancing the reaction rate of HMF oxidation to DFF by a factor of 10 under LED (400 nm). Under illumination of LED, leading to the complete conversion of HMF and the generation of DFF with a yield of 99.7 % within 30 min. Mechanism study shows that the photothermal effect facilitates the kinetic process of the reaction, and accelerated conversion of 4-OH-TEMPO to the oxidatively active species 4-OH-TEMPO + under light-induced action further increased the reaction rate. This research proffers novel insights and references for 4-OH-TEMPO mediated organic synthesis reactions and the design of free-radical photothermal materials.

CAS / MDL: 10031-43-3
研究领域: 材料科学 · 有机化学 · 催化 · 光化学 · 热工学
✓ 已验证 产品关联 DOI 高影响因子
查看原文 查看 PubMed
DALTON TRANSACTIONS · 2020 ·Vol. 49 ·期 13 ·4067-4077 · IF 4.174

Cone-shaped titanate immobilized on polyacrylonitrile nanofibers: hierarchical architecture for effective photocatalytic activity

Mingyue Zhu,Chuanxiang Qin,Jian-jun Wang,Jun Sun,Lixing Dai

A new photocatalytic composite material, based on flexible functional polyacrylonitrile nanofibers (denoted as f-PAN NF), was developed by depositing composite layers of α-TiO2 and cone-shaped titanate (H2Ti5O11·3H2O) successively. The α-TiO2 coated on f-PAN NF as a seed accelerated the nucleation of titanate. Cone-shaped titanate deposited on α-TiO2@f-PAN NF tightly at 35 °C with the assistance of cyanuric acid via Ostwald ripening. Due to the uniform distribution of cone-shaped titanate, the photocatalytic performance of hybrid f-PAN NF was remarkable under LED light irradiation and yielded additional photocatalytic applications as well. In addition, the composite photocatalyst exhibited better reusability and retrievability because of the special design involving a bonding between the nanofibers and layers.

CAS / MDL: 108-80-5 81-88-9
研究领域: 材料科学 · 纳米技术 · 环境工程 · 化学
✓ 已验证 产品关联 DOI PubMed 高影响因子
查看原文 查看 PubMed
Materials Today Sustainability · 2022 · IF 7.244

Dye-sensitized Bi2MoO6 for highly efficient photocatalytic degradation of levofloxacin under LED light irradiation

S. Wei,S. Fan,M. Zhang,J. Ren,B. Jia,Y. Wang,R. Wu,Z. Fang,Q. Liang

Different from traditional dye sensitization by chemisorption in the dark, this work uses electron trapping sites and positively charged rhodamine B dye molecules to achieve electrostatic interaction under irradiation. As the irradiation time increases, the surface oxygen vacancies of Bi 2 MoO 6 as the electron trapping sites gather a large number of electrons forming negative surface, which are tightly bound to the positive rhodamine B dye molecules. In the dye-sensitized Bi 2 MoO 6 system, the electrons located on the oxygen vacancies can reduce the oxidized dyes to ground state. The newly formed ground-state dyes are photoexcited again and inject electrons into the conduction band of the Bi 2 MoO 6 to participate in photodegradation levofloxacin. Then the newly aggregated electrons on the oxygen vacancies repeat the above cycle. The formation of the cyclic path greatly reduces the recombination of electrons and holes in Bi 2 MoO 6 , which increases the efficiency of photocatalytic degradation of levofloxacin from ∼43.5% to ∼98.3% under LED irradiation for 2 h. In addition, the photodegradation pathway of levofloxacin is investigated.

研究领域: 环境科学 · 材料科学 · 化学
✓ 已验证 产品关联 DOI 高影响因子
查看原文 查看 PubMed
已复制

文献关联基于可获得的产品、CAS、DOI 及引用记录。收录不代表作者或出版方对阿拉丁产品的背书,请以原始文献为准。