Highly sensitive and selective detection against toluene gas remains a tremendous challenge in gas sensor applications . In this work, a series of molecular imprinted Ag-LaFeO 3 nanoparticles (IAL NPs) were synthesized in a microwave-assisted colloidal route. Especially, the one prepared with optimal amount of imprint molecules (IAL-2 NPs) have a response of 24.0 to 5 ppm toluene at the optimum working temperature of 215 °C with negligible responses to the other test gases, exhibiting enhanced gas sensing properties for toluene gas at a relatively low working temperature. The improved performance can be attributed to the favorable effect of microwave radiation, the molecular imprinting structure and the sensitization of Ag, which illuminates that IAL-2 NPs is a potential candidate for toluene detection.
Cao Ensi,Feng Yibiao,Guo Zhaoqing,Wang Huihui,Song Guoqing,Zhang Yongjia,Hao Wentao,Sun Li,Nie Zhongquan
To further improve the ethanol sensing performance of LaFeO 3 (LFO) nanoparticles, the co-doping of acceptor and donor at La and Fe sites at equal mole amount was designed to increase the oxygen adsorbing ability of the resultant nanoparticles. A series of (La,Ba)(Fe,Ti)O 3 nanoparticles, with the designed mole ratios of Ba/La (Ti/Fe) as 0, 0.25, 0.33, 0.50, and 1.0, were prepared by a citric sol–gel method. XRD confirmed the main phase of orthorhombic LFO, and the impurity phases of cubic BaTiO 3 (BTO) and orthorhombic BaCO 3 . The incorporation of Ba and Ti into the LFO lattice was verified by the increased unit cell volume of LFO upon more doping. TEM, BET, and XPS measurements indicated that the appropriate co-doping of Ba and Ti into the LFO lattice and the simultaneous existence of BTO and BaCO 3 resulted in smaller grain size, larger BET surface area, and thus higher concentration of adsorbed oxygen species than those in the pristine LFO nanoparticle. Among all (La,Ba)(Fe,Ti)O 3 sensors, the sensor based on the (La,Ba)(Fe,Ti)O 3 nanoparticles with the designed Ba/La = 0.50 exhibited the highest gas response and sensitivity toward ethanol at the prime working temperature of 132 °C, which was ascribed to the higher surface oxygen coverage contributed by the synergistic effect of co-doping and impurity phases on the number of surface active sites and oxygen adsorbing ability.