Establishment of PPy-derived carbon encapsulated LiMn2O4 film electrode and its performance for efficient Li+ electrosorption
Improving the cycle stability and Li + electrosorption rate of the LiMn 2 O 4 (LMO) film electrode in the selective Li + electrosorption process is still a considerable challenge. In this work, a novel polypyrrole (PPy) - derived carbon encapsulated material LiMn 2 O 4 @Carbon/Nitrogen-4 (LMO@CN-4) was prepared by the three-dimensional in-situ polymerization and high-temperature annealing of PPy on the LMO surface. The LMO@CN-4 film electrode showed a faster Li + electrosorption rate, higher lithium-ion selectivity, and higher stability than the LMO film electrode. The maximum capacity of the LMO@CN-4 film electrode for Li + could reach 34.57 mg/g within 40 min in 0.05 mol/L LiCl solution. Even in the simulated concentrated seawater with a low Li + concentration (0.17 g/L), it could quickly reach adsorption equilibrium and maintain the high selectivity of Li + . The adsorption capacity was about 37.14 mg/g and the separation coefficient of α (Li + /Mg 2+ ), α (Li + /Na + ), and α (Li + /Ca 2+ ) was about 228.25, 2110.64, and 1381.89. The carbon encapsulation served as a conductive layer to enhance charge and ion transport. It also provided a buffer layer to prevent the volume collapse of the crystal and the dissolution of Mn. Therefore, the charge and discharge capacity of the LMO@CN-4 film electrode could be maintained at about 80% after 50 cycles at the 1C (148 mAh/g) rate, which was 20% higher than that of the bare LMO. What’s more, the high cycle stability and Li + electrosorption rate of the modified film electrode also suggested its potential for lithium electrosorption from concentration seawater.
危险品化学品经营许可证（带存储）