INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH
·
2024
·
IF 3.8
Jiangxiao Qiao,Jinxin Gan,Fei Gao,Xiangsen Xu,Jiesong Tan,Yiqing Zeng,Feng Zhang,Feng Han,Zhaoxiang Zhong,Weihong Xing
Synergistic removal of nitrogen oxides (NOx) and particulate matter (PM) can be achieved using multifunctional catalytic membranes. In this work, CePO4 nanorods were loaded on the pore surfaces of SiC membranes to construct the CePO4/SiC-X catalytic membranes. The stacked nanorod structure of the CePO4 catalyst layer facilitates the diffusion of gases to the catalyst surface during reactions. Owing to the high specific surface area, rich surface acidity, and strong redox capacity, the CePO4/SiC-400 catalytic membrane exhibits the best ammonia-selective catalytic reduction (NH3–SCR) denitration activity, achieving >90% NO conversion at a temperature of 250–380 °C and negligible N2O byproduct. In addition, the CePO4/SiC-400 catalytic membrane demonstrates excellent H2O and SO2 resistance. The performance of dust filtration and simultaneous dust filtration and denitration at 250–350 °C proposed that the dust rejection efficiency reached more than 99% at various conditions, and the dust filtration process did not affect the NH3–SCR performance of the CePO4/SiC-400 catalytic membrane. From the above results, the CePO4/SiC-400 catalytic membrane presents a broad application prospect in the simultaneous dust removal and denitration of high-temperature flue gas.
研究领域:
环境科学
·
催化材料
·
化学工程
✓ 已验证
产品关联
DOI
高影响因子
FUEL
·
2022
·
IF 8.035
Yiqing Zeng,Weilong Rong,Shule Zhang,Yanan Wang,Qin Zhong
Ammonia selective catalytic reduction (NH 3 -SCR) technique for nitrogen oxide (NO x ) elimination of low temperature flue gas (<200 °C) requires huge energy consumption and operation costs. In this work, a CuO modified V 2 O 5 -WO 3 /TiO 2 (Cu/VWTi) catalyst are constructed to achieve the aim of enhancing the temperature of flue gas via using the heat released by CO oxidation, thereby promoting the NH 3 -SCR of NO x reaction. Benefiting from the synergistic effect between CuO and VWTi in the adsorption and activation of reactants, Cu/VWTi catalyst shows high NO x (>90%) and CO (>90%) removal efficiency at the temperature range of 225–270 °C and a GHSV of 40,000 h −1 . Moreover, it is found that the completely oxidation of 2000 ppm CO can increase the flue gas temperature by about 20 °C. Therefore, developing catalyst that can achieve simultaneously NH 3 -SCR of NO x and CO oxidation is a feasible method to deduce the energy consumption and operation costs of NH 3 -SCR of NO x system in low temperature flue gas. Finally, the reaction process and SO 2 deactivation effect over Cu/VWTi catalyst was studied via in-situ DRIFT. This work might provide some guidance for the design of catalysts to eliminate multiple pollutants.
研究领域:
环境科学
·
催化化学
✓ 已验证
产品关联
DOI
高影响因子
SEPARATION AND PURIFICATION TECHNOLOGY
·
2023
·
IF 8.6
Xiangsen Xu,Fengye Lyu,Jiahao Chen,Yiqing Zeng,Zhaoxiang Zhong,Feng Zhang,Weihong Xing
In this work, TiO 2 nanocones grown on SiC membrane was used as the support of V 2 O 5 -WO 3 species to prepare V 2 O 5 -WO 3 /TiO 2 @SiC (VWTi(C-X)@SiC) catalytic membrane for dust filtration and NH 3 -SCR denitration. On account of the large specific surface area, abundant surface acid sites and prominent redox property, the optimized VWTi(C-550)@SiC catalytic membrane shows >90% NO removal efficiency at the temperature of 280–360 °C, which are much higher than VWTi(P-550)/SiC catalytic membrane (TiO 2 nanoparticles prepared by traditional vacuum coating titanium sol method was used as the support of V 2 O 5 -WO 3 species, NO conversion <80% at whole tested temperature). Additionally, VWTi(C-550)@SiC displays superior stability during the SO 2 + H 2 O resistance and 300 h long-term test at 300 °C, and exhibits an excellent dust filtration performance (2.5 μm SiO 2 particles interception rate exceeded 99.99%) under all test conditions. More importantly, the structure of nanocones decrease the influence of tensile stresses due to the different thermal expansion coefficients of TiO 2 and SiC membranes, which significantly suppress the fall of VWTi catalyst layer from the surface of SiC during pulse-jet cleaning. Among above results, it can be concluded that the optimized VWTi(C-550)@SiC catalytic membrane shows a prosperous application prospect for the simultaneously dust filtration and NH 3 -SCR denitration of medium–high temperature flue gas .
研究领域:
环境科学
·
催化材料
·
能源工程
✓ 已验证
产品关联
DOI
高影响因子
SEPARATION AND PURIFICATION TECHNOLOGY
·
2022
·
IF 9.136
Huixian Zhou,Hui Zhong,Yiqing Zeng,Yutang Kang,Bin Chen,Shuanglu Ma,Yifan Li,Yu Zhang,Shasha Feng,Zhaoxiang Zhong,Weihong Xing
The strategy of constructing catalytic membrane has a significant influence on its structure and performance. In this work, Co 3 O 4 -C x @SiO 2 nanofiber membranes (NFMs) were fabricated by an in-situ growth–pyrolysis–oxidation strategy. The Co 3 O 4 -C x catalyst derived from ZIF-67 was wrapped around nanofibers, which helps to maintain a stable membrane structure, then suppressing the reduction of gas permeability. Among the Co 3 O 4 -C x catalyst, the carbon skeleton can prevent the agglomeration of Co 3 O 4 nanoparticles, obtaining an ultra-fine Co 3 O 4 nanoparticles with high dispersibility, redox property and surface area. The obtained Co 3 O 4 -C 300 @SiO 2 NFM exhibits outstanding ammonia selective catalytic reduction (NH 3 -SCR) denitrification activity (T 90 = 225 °C at a GHSV of 77,000 h −1 ). The effect of catalyst loading on PM 2.5 filtration performance of SiO 2 NFM was also tested. Co 3 O 4 -C 300 @SiO 2 NFM has higher filtration efficiency (99.99%) than SiO 2 NFM at a lower pressure drop of 58 Pa, which suggests that catalyst loading via our method can improve the filtration performance of SiO 2 NFM. This work might provide a universal strategy for the design and preparation of highly efficient catalytic membrane.
研究领域:
环境科学
·
材料科学
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）