CHEMICAL ENGINEERING JOURNAL
·
2022
·
IF 16.744
Qungui Wang,Keli Wang,Cheng Yan,Xiankan Zeng,Xuehai Fu,Jingjing Cao,Shiyu Yang,Wen Li,Xiangrong Chen,Weiqing Yang
Effectively balancing carrier injection of perovskite LEDs (PeLEDs) for next-generation display and illumination urgently needs for molecularly understanding carrier injection behavior of electron transport layer (ETL)/perovskite toward further developing high performance PeLEDs. Here, we molecularly reveal the electron injection behaviors of PeLEDs by theoretically-experimentally decoupling the electron transport of ETLs and electron injection of TmPyPB/perovskite and TPBi/perovskite. Resulted, the better molecular planarity bridging effect (MPBE) of TmPyPB than TPBi can effectively increase electronic-coupling for the improved electron transport ability and significantly decrease injection barrier for the enhanced electron injection capability, intrinsically leading to a more balanced carrier injection and a less electron accumulation of PeLEDs. Compared to TPBi-based PeLEDs, the TmPyPB-based PeLEDs present the obviously-increased average EQE, current efficiency, power efficiency and luminance by 44 %, 63 %, 43 % and 100 %, respectively. Meanwhile, this PeLED shows a higher voltage tolerance characteristic of 7.5 V than that of TPBi-based PeLEDs (6.25 V). Therefore, this work may provide a fundamental insight into carrier injection behavior of PeLEDs for effectively-regulating its carrier injection balance and further for its greatly-facilitated commercialization.
研究领域:
材料科学
·
光学工程
✓ 已验证
产品关联
DOI
高影响因子
ORGANIC ELECTRONICS
·
2020
·
IF 3.31
Rongmei Yu,Furong Yin,Chunying Pu,Haizhen Song,Xiumei Xu,Han Zhang,Wenyu Ji
Although much effort has been made to the cadmium-free quantum dot light emitting diodes (QLEDs), it is still a big challenge to achieve an efficient eco-friendly QLED. Here, an extremely efficient QLED based on Ag–In–Zn–S QDs is constructed with the insertion of an 1,3,5-tris(N-phenylbenzimidazole-2-yl)benzene (TPBi) hole-spacing interlayer. The electrical properties of single carrier devices demonstrate the TPBi blocks the hole injection, leading to a more balanced charge injection in the device. Transient electroluminescence measurements confirm that the hole accumulation adjacent QDs is dramatically suppressed after the insertion of TPBi, hence limiting the interactions between excitons and holes. Consequently, the peak current (power) efficiency of 6.0 cd/A (6.5 lm/W) is achieved. To the best of our knowledge, this is the record efficiency for the Ag–In–Zn–S QLEDs reported to date. We anticipate this work will provide a new route for optimizing the performance of Cd-free QLEDs.
研究领域:
材料科学
·
光电子学
✓ 已验证
产品关联
DOI
高影响因子
CHINESE JOURNAL OF CHEMICAL ENGINEERING
·
2023
·
IF 3.8
Jingzhou Guo,Yuanzuo Zou,Bo Shi,Yuan Pu,Jiexin Wang,Dan Wang,Jianfeng Chen
Solubility enhancement has been a priority to overcome poor solubility with optoelectronic molecules for solution-processable devices. This study aims to obtain experimental data on the effect of particle sizes on the solubility properties of several typical optoelectronic molecules in organic solvents, including the solubility results of 1,3-bis(9-carbazolyl)benzene (mCP), 1,3,5-tris(1-phenyl-1H-benzimidazol-2-yl)benzene (TPBi) and 2-(4- tert -butylphenyl)-5-(4-biphenyl)-1,3,4-oxadiazole (PBD) in ethanol and acetonitrile , respectively. Nanoparticles of mCP, TPBi and PBD with sizes from dozens to several hundred nanometers were prepared by solvent antisolvent precipitation method and their solubility were determined by using isothermal saturation method. The saturation solubility of nanoparticles of three kinds of optoelectronic molecules exhibited increase of 12.9%−25.7% in comparison to the same raw materials in the form of microparticles. The experimental evidence indicates that nanonization technology is a feasible way to make optoelectronic molecules dissolve in liquids with enhanced solubility.
研究领域:
材料科学
·
光电子学
·
纳米技术
·
化学工程
✓ 已验证
产品关联
DOI
高影响因子
JOURNAL OF CHEMICAL AND ENGINEERING DATA
·
2021
·
IF 2.694
Renxin Wang,Yuanzuo Zou,Jingzhou Guo,Yuan Pu,Dan Wang
1,3,5-Tris(1-phenyl-1H-benzimidazol-2-yl)benzene (TPBi) is normally used as functional materials in organic light-emitting diodes (OLEDs) and the information about the solubilities of TPBi in organic solvents is crucial for the preparation of inks toward inkjet printing technology, which is considered to be a next-generation manufacturing method for OLED production. The solubilities of TPBi in 12 kinds of organic solvents, including n-hexane, cyclohexane, methanol, ethanol, isopropanol, n-butanol, acetonitrile, ethyl acetate, dimethyl sulfoxide, tetrahydrofuran, chlorobenzene, and trichloromethane, at the temperature range from 283.15 to 323.15 K and atmospheric pressure were determined based on the isothermal saturation method. The obtained solubility data were correlated by the modified Apelblat equation and the correlated results exhibited good agreement with the experimental data. The nanonization of TPBi was conducted via high gravity-assisted solvent/antisolvent precipitation processing, which showed a beneficial effect for film formation.
研究领域:
材料科学
·
化学工程
·
纳米技术
·
有机电子学
✓ 已验证
产品关联
DOI
高影响因子
危险品化学品经营许可证（带存储）