计算溶液所需的质量、体积或浓度。
,适用于对基线干扰要求严格的色谱和分析工作流程。
2-8°C储存。低温运输 。请查阅批次 COA 获取详细规格。
SDS、COA、产品数据表及规格说明书均可下载。可通过批号查询获取批次 COA。
在色谱分析、有机合成和交叉偶联反应领域已被 0 篇同行评审文献引用。
Product Description
alpha-D-mannosidase, p-nitrophenyl-alpha-mannosidase, alpha-D-mannopyranosidase, alpha mannosidase, exo-alpha-mannosidase
Alpha Mannosidase from Jack Bean cleaves α(1-2,3,6)-linked mannose.
This enzyme is often used in conjunction with Core Alpha-(1-6) Mannosidase (E-AM02) if a noncleavable core α(1-6) mannose is present on the substrate.
Specificty
All Alpha-(1-2,3,6)-linked mannose
Purity
Each lot of α(1-2,3,6) mannosidase is tested for contaminating substances by incubating the enzyme for 24 hours at 37°C with substrates indicated in the table below. No detectable activity is evident for any of these potential contaminants. The detection limit of this assay is 5 μU/mL (IUB).
For the protease assay, 10 μg of denatured BSA is incubated for 24 hours with 2 μl of enzyme. Analysis of the BSA band after SDS-PAGE should show no evidence of degradation.
Molecular weight
two polypeptides of 64,000 and 44,000 daltons
Specific Activity Assay
One unit of Alpha Mannosidase is defined as the amount of enzyme required to hydrolyze 1 µmole of p-nitrophenyl-alpha-p-mannoside to p-nitrophenol in 1 minute at pH 5.0 and 37˚C.
Contents
Alpha-(1-2,3,6) Mannosidase in 150 mM sodium phosphate, 0.1 mM ZnCl2 pH 7.5. (pH 7.5).
Included with 20 µL and 60 µL pack sizes:
200 µl 5x Reaction Buffer 5.0 (250 mM sodium phosphate, pH 5.0).
Suggested usage
1. Add up to 1 nmol of oligosaccharide.
2. Add deionized water to 15 µl.
3. Add 4 µl 5x Reaction Buffer 5.0.
4. Add 1 µL of enzyme
5. Incubate ten minutes at 37˚C.