流式固定透化试剂盒

货号: B1511174
有货
级别和纯度: BioReagent ? 生物试剂级(BioReagent)—— 经测试适用于生命科学和分子生物学。适用于需要生物相容性的细胞培养、检测和生化工作。 适用于分析 ? 适用于分析 —— 纯度满足一般分析程序。作为常规方法中可靠的分析试剂使用。 比色法 ? 比色级 —— 适用于显色定量检测的纯度。当试剂纯度影响显色强度和准确度时使用。
★
规格
库存
价格
数量
50T
B1511174-50T
现货 Stock Image
¥499.90
100T
B1511174-100T
现货 Stock Image
¥859.90
500T
B1511174-500T
现货 Stock Image
¥2,379.90
请输入您要添加的产品数量

概述

  流式固定/透化试剂盒包含优化配制的缓冲液,用于固定和透化细胞,用于细胞内抗原的免疫荧光染色,以便通过流式细胞仪进行分析。

使用方法

1. 以 400g 离心 5 分钟沉淀细胞,然后用 PBS 重悬至密度为 10^7 个细胞/毫升。

2. 将 100 μL 细胞悬液(10^6 个细胞)分装到 96 孔板的每个孔中。

3. 可选:表面抗原染色。

    a. 用 PBS 稀释适量表面抗原抗体。

    b. 每孔加入 100 μL 抗体溶液。

    c. 室温孵育 15 分钟。

    d. 用 200 μL PBS 洗涤细胞两次,方法同步骤 1。

    e. 用 100 μL PBS 重悬细胞。

4. 每孔加入 100 μL 流式细胞术固定缓冲液,轻轻涡旋混匀。

5. 室温孵育 20 分钟。

6. 以 400g 离心 5 分钟。用 200 μL PBS 重悬,洗涤细胞两次,每次以 400g 离心 5 分钟,然后轻轻倒掉上清液。

7. 每孔加入 100 μL 流式细胞术透化缓冲液,轻轻涡旋混匀。

8. 室温孵育 10 分钟。

9. 用 PBS 洗涤细胞两次,方法同步骤 6。

10. 用 PBS 稀释适量一抗,轻轻涡旋混匀。

11. 每管加入 100 μL 一抗溶液。

12. 室温孵育样品 30 分钟。

13. 用 PBS 洗涤细胞两次,方法同步骤 6。注:如果使用荧光标记的一抗,加入 200 μL PBS 后即可进行流式细胞术分析。如果使用未标记的一抗和荧光标记的二抗,则继续步骤 14。

14. 用 PBS 稀释适量荧光二抗,轻轻涡旋混匀。

15. 每管加入 100 μL 二抗溶液。

16. 室温避光孵育 30 分钟。

17. 用 PBS 洗涤细胞两次,方法同步骤 6。

18. 用 200 μL PBS 重悬细胞沉淀,然后进行流式细胞术分析。

注意事项

1. 本产品含有甲醛,使用时需要做好个人防护措施,佩戴手套、穿实验服等,以避免接触眼睛或皮肤。

2. 孵育时,使液体覆盖住细胞,不要使细胞粘在管壁,防止细胞处理不充分导致阴性信号群。

结果展示

图1: Jurkat细胞用流式细胞术固定/透化试剂盒(B1511174)进行固定和透化,然后孵育 alpha Tubulin Mouse mAb (AF488) (Ab219162),在 4°C 避光条件下染色 30 分钟(红色)。蓝色为同型对照:Mouse IgG (AF488) (Ab190245)。黑色为未标记对照(未与一抗孵育的细胞)。

  Flow Cytometry Fixation/Permeabilization Kit contains optimally formulated buffers for fixation and permeabilization of cells for immunofluorescence staining of intracellular antigens for analysis by flow cytometry.

Protocol

1. Pellet cells by centrifuging at 400g for 5 minutes and resuspend in PBS at a density of 10^7 cells/mL.

2. Aliquot 100 μL of cell suspension (10^6 cells) per tube into 96 well plate.

3. Optional: Staining for surface antigens.

    a. Dilute the appropriate amount of surface antigen antibody(s) in PBS.

    b. Add 100 μL of the antibody solution to each well.

    c. Incubate for 15 minutes at room temperature.

    d. Wash cells twice with 200 μL PBS as described in step 1.

    e. Resuspend cells in 100 μL PBS.

4. Add 100 μL of Flow Cytometry Fixation Buffer to each sample and vortex gently to mix.

5. Incubate for 20 minutes at room temperature.

6. Centrifuge for 5 minutes at 400g. Wash cells twice by resuspending in 200 μL PBS, then centrifuge for 5 minutes at 400g, and gently pour off supernatant.

7. Add 100 μL of Flow Cytometry Permeabilization Buffer to each sample and vortex gently to mix.

8. Incubate for 10 minutes at room temperature.

9. Wash cells twice with PBS as described in step 6.

10. Dilute the appropriate amount of primary antibody in PBS and vortex gently to mix.

11. Add 100 μL of the primary antibody solution to each tube.

12. Incubate samples at room temperature for 30 minutes.

13. Wash cells twice with PBS as described in step 6.

Note: If staining with fluorescently-labeled primary antibodies, add 200 μL PBS and analyze by flow cytometry. If staining with unconjugated primary antibodies and fluorescently-labeled secondary antibodies, proceed to step 14.

14. Dilute the appropriate amount of fluorescent secondary antibody in PBS and vortex gently to mix.

15. Add 100 μL of the secondary antibody solution to each tube.

16. Incubate for 30 minutes at room temperature in the dark.

17. Wash cells twice with PBS as described in step 6.

18. Resuspend cell pellet in 200 μL PBS and analyze by flow cytometry.

Notes

1. This product contains formaldehyde. Personal protective measures should be taken during use, such as wearing gloves and a lab coat, to avoid contact with eyes or skin.

2. During incubation, ensure that the liquid covers the cells and that the cells do not adhere to the tube wall, to prevent insufficient cell processing that may lead to a negative signal population.

Results Presentation

Figure1: Jurkat cells were fixed and permeabilized with Flow Cytometry Fixation/Permeabilization Kit (B1511174) and then stained with alpha Tubulin Mouse mAb (AF488) (Ab219162) (red) at for 30 minutes at 4°C in the dark. Blue - Mouse IgG (AF488) (Ab190245). Black - Unlabelled control, cells without incubation with primary antibody.

规格

规格或纯度
BioReagent,比色法,适用于分析
英文名称
Flow Cytometry Fixation/Permeabilization Kit
应用
Flow Cytometry
检测方法
流式细胞术
定量&半定量
定量
检测仪器
流式细胞仪
检测时长
90 min
储存与运输
储存条件
2-8°C储存
运输条件
低温运输
稳定性与储存
各组分在相应的储存条件下保质期1年。
组分与储存
B1511174Component50T100T500TStorage conditions
B1511174AFlow Cytometry Fixation Buffer5 mL  10 mL  50 mL  2-8℃
B1511174BFlow Cytometry Permeabilization Buffer5 mL  10 mL  50 mL  2-8℃
图片
Flow Cytometry Fixation/Permeabilization Kit (B1511174)- Flow Cytometry
 Flow cytometry analysis of alpha Tubulin expression by Jurkat cells (red) compared to an isotype control (blue). Cells were fixed and permeabilized with Flow Cytometry Fixation/Permeabilization Kit (B1511174) and then stained with alpha Tubulin Mouse mAb (AF488) (Ab219162) (red) at 0.7μg/mL for 30 minutes at 4°C in the dark. Blue - Mouse IgG (AF488) (Ab190245). Black - Unlabelled control, cells without incubation with primary antibody.

高级数据

质检证书(CoA,COO,BSE/TSE 和分析图谱)
C of A & Other Certificates(BSE/TSE, COO):
输入批号以搜索分析图谱:

通过匹配包装上的批号来查找并下载产品的 COA,每批产品都进行了严格的验证,您可放心使用!

找到3个结果

批号(Lot Number) 证书类型 货号
ZJ26F0535283ZJ26F0535283 分析证书 B1511174
ZJ26F0535284ZJ26F0535284 分析证书 B1511174
ZJ26F0535285ZJ26F0535285 分析证书 B1511174
技术文档和文章
溶液计算器

常见问题

什么是「适用于分析」?
「适用于分析」是一个明确定义的分析纯度级别,适用于定量分析方法。它规定了最低含量百分比、对常见杂质(水分、重金属、灼烧残渣)的受控限值,以及批间一致性。「适用于分析」是几个纯度级别之一——请根据方法的灵敏度和监管要求进行选择。
什么是「BioReagent」?
「BioReagent」表示该产品经过加工和检测,适用于生物和生化应用。规格可能包括内毒素限值、微生物控制、无菌性、低 DNase/RNase/蛋白酶活性,以及在相关情况下的生物活性验证。
本产品应如何储存?
请于2–8 °C条件下保存。需冷藏保存以维持规定的有效期。
本产品如何运输?
本产品采用湿冰冷藏运输。收货后请立即拆包,并按上述储存条件保存。
如何获取批次专用COA?
每个订单都会随附分析证书(COA),您也可以从账户订单历史中下载。如需订购前的COA,请联系您的客户代表,或使用PDP上的"申请COA"按钮——我们将提供代表性批次的COA。

需要帮助选择级别?

我们的级别选择指南涵盖了目录中所有的变体的纯度、稳定剂状态和应用适用性。

查看 BioReagent 级别指南 → 查看 Suitable for Analysis 级别指南 → 查看 Colorimetry 级别指南 →