计算溶液所需的质量、体积或浓度。
BioReagent,无菌过滤 级 ,适用于对基线干扰要求严格的色谱和分析工作流程。
2-8°C储存。低温运输 。请查阅批次 COA 获取详细规格。
SDS、COA、产品数据表及规格说明书均可下载。可通过批号查询获取批次 COA。
在色谱分析、有机合成和交叉偶联反应领域已被 0 篇同行评审文献引用。
产品介绍
细胞透化缓冲液适用于胞内染色步骤,适用于胞内细胞因子或其他细胞内蛋白质进行染色前的细胞制备。该缓冲液主要用于细胞固定后的透化处理,以10倍浓缩液形式提供,使用前需用去离子水稀释。
主要组分:
磷酸盐缓冲液 (PBS)
Proclin 300: 0.05% (v/v) (作为防腐剂)
使用方法:
离心固定后的细胞并弃去上清液。用去离子水将流式细胞通透剂 (10×) 稀释至1倍工作浓度。向固定后的细胞中直接加入稀释好的细胞通透剂,每100万个细胞使用约100微升。室温孵育10分钟。在抗体孵育前,可用磷酸盐缓冲盐水(PBS)洗涤细胞以去除细胞通透剂,但此步骤并非必需。
注意事项:
1、Triton™ X-100去垢剂可能使细胞沉淀的附着力降低,因此在离心后移除上清液时需注意保留细胞。
2、建议根据具体应用场景,通过预实验确定该试剂的最佳使用浓度。
Product Introduction
Cell Permeabilization Buffer is useful for intracellular staining procedures, e.g., in preparation of cells for staining intracellular cytokines or other proteins. Cell Permeabilization Buffer is used to permeabilize cells following fixation. It is supplied as a 10× solution and should be diluted in deionized water prior to use.
Key Components:
Phosphate Buffered Saline (PBS)
Triton™ X-100: 3% (v/v)
Proclin 300: 0.05% (v/v) (as preservative)
Usage Protocol:
Centrifuge fixed cells and remove supernatant. Dilute Cell Permeabilization Buffer (10×) to 1× in DI water. Add diluted Cell Permeabilization Buffer directly to fixed cells, using approximately 100 µl per 1 million cells. Incubate for 10 min at room temperature. Cells may be washed with phosphate-buffered saline (PBS) to remove Cell Permeabilization Buffer prior to antibody incubation, but it is not necessary.
Precautions:
1、The Triton™ X-100 detergent can reduce cell pellet adhesion, so care should be taken to retain cells when removing supernatant following centrifugation.
2、It is recommended that the reagent be titrated for optimal performance for each application.
通过匹配包装上的批号来查找并下载产品的 COA,每批产品都进行了严格的验证,您可放心使用!
| 批号(Lot Number) | 证书类型 | 货号 |
|---|---|---|
| 分析证书 | F1508364 |