TiO2/activated carbon synthesized by microwave-assisted heating for tetracycline photodegradation

A furfural residue-derived activated carbon (AC) supported black-TiO 2 photocatalyst was successfully prepared by ultrasonic-assisted sol-gel treatment (USG) and solvothermal treatment (ST) combined with microwave-assisted heating (MH). The prepared composites were characterized and evaluated based on the degradation of tetracycline hydrochloride (TC) under ultraviolet (UV) illumination. The average TiO 2 nanoparticle size of the as-synthesized catalysts was between 9 and 11 nm. The bandgap of TiO 2 -USGM was 1.6 eV, much lower than that of other reference catalysts. Organic carbon and AC in the catalyst play positive roles in reducing the band gap (e.g. 1.6∼2.6 eV) and improving visible-light absorption. The oxygen vacancies are responsible for UV–visible absorption. Adding AC into black TiO 2 resulted in a lower degree of recombination of photogenerated electrons. Mott-Schottky plots showed that AC-containing TiO 2 @AC-STM reduced the value of conduction band value from −0.59 eV to −0.24 eV, which is beneficial to photogenerated electrons. Compared with TiO 2 , the Ti–O–C and Ti–C- in TiO 2 @AC remarkably improved the adsorption and catalytic efficiency of TC. In a near-neutral pH environment, TiO 2 @AC-STM and TiO 2 @AC-USGM exhibited high removal efficiencies (88.0% and 75.7%, respectively) and degradation rates (0.0418 and 0.0302 μmol/g/s, respectively) at a catalyst load of 0.25 g/L. Notably, the catalyst can be effectively used over a wide range of pH (6–9). The solution pH after treatment was close to neutral, which is advantageous for wastewater treatment . The activation energies were found to be approximately 3.47 kJ/mol. The thermodynamic parameters showed that the photodegradation process was non-spontaneous and endothermic. Based on the trapping experiments, O 2 ⋅ - was mainly responsible for TC photodegradation over TiO 2 @AC-STM, followed by h + . The TC degradation pathways and catalyst stability were also investigated. Biomass-derived carbon-supported catalysts have great potential for waste biomass utilization as green, and low-cost catalysts.