Ultra-low pressure PES ultrafiltration membrane with high-flux and enhanced anti-oil-fouling properties prepared via in-situ polycondensation of polyamic acid

Polyamic acid (PAA) is a flexible polymer and has abundant valuable hydrophilic groups. Herein, we developed an ultra-low pressure ultrafiltration (UF) membrane by integrating PAA into the polyethersulfone (PES) matrix via the “in-situ polycondensation” method. PAA was well compatible with PES and distributed uniformly in the membrane. The introduction of PAA improved membrane hydrophilicity. Meanwhile, the membrane pore structures were also refined. The membrane exhibited an excellent permeability under ultra-low pressure due to its improvement of hydrophilicity and pore structures. Under 0.3 bar, compare with the water flux of PES membrane, PES/PAA membrane improved nearly 2 times (571.05 L/(m 2 ·h)), with a high BSA rejection (≥90%). Even under a lower pressure, 0.1 bar, >300 L/(m 2 ·h) still can be achieved. Interestingly, the membrane we developed could maintain a high performance after drying, and then is very suitable for dry preservation. PES/PAA membrane showed a high oil removal (≥92%) and could remove oil from water effectively. Besides, the membrane exhibited excellent anti-oil-fouling properties. The flux recovery rate of PES/PAA (70.0%) far exceeds that of PES (37.9%) after three filtration and cleaning cycles. The membrane we developed is very valuable in oily wastewater treatment .