Digital light processing of Si-based composite ceramics and bulk silica ceramics from a high solid loading polysiloxane/SiO2 slurry

Nowadays, 3D polymer-derived silicon oxycarbide ceramics (SiOC) can be fabricated by the stereolithography method successfully. However, due to their intrinsically poor ceramic content and the large thermal shrinkage during the pyrolysis, it is difficult for the bulk 3D polysiloxane precursors to be pyrolyzed into dense 3D-ceramics. Herein, the ceramic content of the photocurable polysiloxane precursors was increased by adding a large amount of SiO 2 powders into the low solid content epoxy-acrylic siloxane. After being added with proper dispersant, the viscosity of the high solid loading polysiloxane/SiO 2 slurry can reach a proper level. Bulk 3D-silica ceramics with the wall-thickness around 8 mm can be conveniently fabricated from the polysiloxane/SiO 2 slurry by stereolithography and a two-step sintering process. The addition of a proper sintering aid NaF can promote the 3D-PSO/SiO 2 precursor to be converted into dense and crack-free 3D-silica ceramics with good mechanical proprieties.