摘要
Sewage sludge is a primary pathway for microplastics (MPs) entering into terrestrial ecosystems . However, a standardized method to analyze MP in sludge is lacking due to its high organic matter. This study investigated the extraction efficiency of six MPs in five solid matrices, i.e. sewage sludge, cattle manure, soil, sediment and silicon dioxide. Results show lower extraction efficiency of 87.2% for MPs in sludge compared with that in other matrices, especially polyethylene terephthalate (PET) (only 27.8%). The possible reason was that the presence of extracellular polymeric substances within the sludge hinders the MPs to float. Therefore, five protocols, i.e. hydrogen peroxide (H 2 O 2 ), Fenton , nitric acid (HNO 3 ), hydrochloric acid (HCl) and sodium hydroxide (NaOH) were used to pretreat the sludge and optimize the MP extraction. The sludge pretreated by H 2 O 2 , Fenton and 1 M of acids had higher MP extraction efficiency than the raw sludge due to higher extraction of the PET. The MP extraction efficiency in the sludge first increased, and subsequently decreased with the soluble chemical oxygen demand (SCOD) content, implying that moderate dissolution of sludge organic matter is beneficial to the MP extraction. Quantitative analysis of the changes in the MP physicochemical characteristics after the pretreatments indicated that polyamide (PA) and PET are not resistant to acid and alkali treatment, respectively. Principal component analysis shows that the effect of pretreatments on the MPs follows a decreasing sequence: alkali > high concentration of acids > low concentration of acids > H 2 O 2 and Fenton. Additionally, the susceptibility of the MPs to the pretreatments follows a decreasing sequence: PET, PA and polymethyl methacrylate (PMMA) > polystyrene (PS) > polyethylene (PE) and polypropylene (PP). The findings supply novel insights into the effect of chemical pretreatments on MP extraction in sewage sludge.
危险品化学品经营许可证（带存储）