Selective removal and persulfate catalytic decomposition of diethyl phthalate from contaminated water on modified MIL100 through surface molecular imprinting

Adsorptive removal of phthalate esters from wastewater combined with their persulfate (PS) catalytic degradation has attracted the attention of many researchers. In this study, the adsorptive and catalytic properties of an MIL100 material obtained by a green synthetic route have been optimized by a surface molecular imprinting technique. Results have shown that there are two steps in the molecular imprinting process. A polymerization is first carried out in the internal channels of the material and the imprinting layer is then formed on the surface. The relative proportions of the starting materials for the synthesis have been optimized through the design of a three-dimensional response surface. The amount of pollutant adsorbed was increased fourfold after surface imprinting, reaching 13.6 mg g −1 . The homogeneity of the recognition sites has been evaluated by dynamics calculations and the Freundlich equation. The selective adsorption ability of the material for diethyl phthalate was improved, and the process involved chemical adsorption. The catalytic properties of the material after imprinting were increased about 1.5-fold, indicating that selective adsorption is important. Such molecularly imprinted polymers may potentially serve as good functional materials for the removal of phthalate esters from wastewater.