Facile one-pot synthesis of cellulose nanocrystal-supported hollow CuFe2O4 nanoparticles as efficient catalyst for 4-nitrophenol reduction

A facile and efficient one-pot method for the synthesis of well-dispersed hollow CuFe 2 O 4 nanoparticles (H-CuFe 2 O 4 NPs) in the presence of cellulose nanocrystals (CNC) as the support was described. Based on the one-pot solvothermal condition control, magnetic H-CuFe 2 O 4 NPs were in-situ grown on the CNC surface uniformly. TEM images indicated good dispersity of H-CuFe 2 O 4 NPs with uniform size of 300 nm. The catalytic activity of H-CuFe 2 O 4 /CNC was tested in the catalytic reduction of 4-nitrophenol (4-NP) in aqueous solution. Compared with most CNC-based ferrite catalysts, H-CuFe 2 O 4 /CNC catalyst exhibited an excellent catalytic activity toward the reduction of 4-NP. The catalytic performance of H-CuFe 2 O 4 /CNC catalyst was remarkably enhanced with the rate constant of 3.24 s −1  g −1 , which was higher than H-CuFe 2 O 4 NPs (0.50 s −1  g −1 ). The high catalytic activity was attributed to the introduction of CNC and the special hollow mesostructure of H-CuFe 2 O 4 NPs. In addition, the H-CuFe 2 O 4 /CNC catalyst promised good conversion efficiency without significant decrease even after 10 cycles, confirming relatively high stability. Because of its environmental sustainability and magnetic separability, H-CuFe 2 O 4 /CNC catalyst was shown to indicate that the ferrite nanoparticles supported on CNC were acted as a promising catalyst and exhibited potential applications in numerous ferrite based catalytic reactions. ᅟ