Synergistic effect of combined UV-LED and chlorine treatment on Bacillus subtilis spore inactivation

An ultraviolet (UV)-based advanced oxidation process (AOP) for disinfecting water is introduced in this paper. This study aimed to evaluate the potential of UV light-emitting diodes (UV-LEDs)/chlorine AOP (UV/Cl 2 ) for Bacillus subtilis spore inactivation. Chlorine was combined with 265 and 280 nm LEDs (UV 265 /Cl 2 , UV 280 /Cl 2 ) and investigated. The addition of 4.0 mg/L of free chlorine at pH 7.0 in the presence of 125 mJ/cm 2 of UV irradiation resulted in an additional 1.8-log reduction in UV 265 /Cl 2 and 1.5-log reduction in UV 280 /Cl 2 . There was no observed enhancement in spore inactivation with the addition of a radical scavenger, t-BuOH, which indicated the role of • OH in the synergistic effect. To quantitatively evaluate the synergism, the primary treatment with UV/Cl 2 was followed by further UV or Cl 2 treatment. After UV/Cl 2 pretreatment at different pH levels, the 265 and 280 nm LEDs treatment enhanced an approximate 0.4–0.5-log reduction compared to UV only, and Cl 2 treatment enhanced an approximate 0.7–1.1-log reduction compared to Cl 2 only. In addition, at pH 7.0, in UV 265 /Cl 2 -Cl 2 and UV 280 /Cl 2 -Cl 2 , the inactivation rate constant k increased by approximately 2 and 1.5 times, respectively. The CT for the lag phases ( CT lag ) reduced to approximately 67 and 58%, respectively. Similar results were obtained at pH 7.5 and 8.0, and in the secondary effluent. The synergistic effect on spore inactivation suggested that the pathogen inactivation efficiency of sequential UV and chlorine disinfection processes, which are commonly applied, can be significantly enhanced by adding chlorine prior to UV treatment .