A novel polyesteramide thin film composite nanofiltration membrane prepared by interfacial polymerization of serinol and trimesoyl chloride (TMC) catalyzed by 4‑dimethylaminopyridine (DMAP)

In order to integrate the advantages of polyamide thin film composite (TFC) nanofiltration (NF) membranes and that of polyester TFC NF membranes, a novel polyesteramide (PEA) TFC NF membrane was prepared by interfacial polymerization between serinol and trimesoyl chloride (TMC) and catalyzed by 4-dimethylaminopyridine (DMAP) on a flat-sheet polyethersulfone (PES) substrate membrane. The membrane performance was maximized by optimizing different preparation parameters. The reaction process was divided into four basic patterns. X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy confirmed the membrane had a partially cross-linked active layer that contained ester bonds, amide bonds and residual hydroxyl groups. Morphology analysis showed the surface of the PEA-TFC-NF membrane was grainy, which was different from the typical polyamide membranes. The contact angle and zeta potential measurements confirmed the PEA-TFC-NF membrane was highly hydrophilic and negatively charged across the entire pH range tested. The optimized PEA-TFC-NF membrane had a MWCO of 474   Da and water permeability of 6.0   L   m −2   h −1   bar −1 at 0.5   MPa and 25   °C. The membrane salt rejections followed the order of Na 2 SO 4 > MgSO 4 > NaCl > MgCl 2 , which were 96.27%, 83.92%, 58.68% and 28.76%, respectively. Moreover, the PEA-TFC-NF membrane displayed good antifouling ability.