Customized Copolymer composite coatings for carbon capture Environments: Corrosion inhibition and CO2 barrier Synergy

Global warming is attributed to excessive emissions of greenhouse gases, which are being addressed through the deployment of carbon capture technologies aimed at mitigating climate change. However, this approach faces significant challenges, as high concentrations of CO 2 pose a huge risk of corrosion, compromising integrity. The active inhibitor polyfluoroaniline grown on the surface of graphene (Gr-PFAN) is encapsulated in epoxy novolac (EN) coating. And highly reactive nitrogen-containing poly(p-phenylenediamine-fluoroaniline) (Gr-PPFAN) was synthesized by changing the polymerization monomer. For the first time, primary amine nitrogen-containing active sites are discussed in CO 2 shielding material. The gas transmission rate (GTR) test showed that the GTR of the composite film containing Gr-PPFAN was 3.7 times higher than that of Gr-PFAN. And the presence of highly reactive amines in the polymer mass transfer behavior was calculated by molecular simulation. Therefore, the PPFAN coating is a serious failure in H 2 O-CO 2 environment. The introduction of the low content of active sites in Gr-PFAN into the epoxy resin matrix resulted in significant enhancement of the H 2 O, H 2 O-CO 2 and H + corrosion resistance. The small amount of active amine not only enhances the phase interface between the resin and the flake filler, but also facilitates the formation of a protective layer on the metal surface. Experimental results demonstrated that Gr-PFAN/EN exhibited the highest |Z| 0.01 Hz value (3.5 × 1011 O × cm 2 ) after 90 days of immersion in 3.5 wt% NaCl solution and 1.5 × 1011 O × cm 2 for 30 days in the carbon capture environment. Furthermore, it makes Gr-PFAN/EN a promising candidate for practical applications in CO 2 capture projects. The findings provide a scientific basis for the development of efficient anti-corrosion coatings suitable for carbon capture technologies.