已核实 DOI 相关产品: 0

Polyethylenimine-impregnated resins: The effect of support structures on selective adsorption for CO2 from simulated biogas

Journal 2018 · IF 6.735 · 发表于 2018 年 8 月 31 日
作者: Haiyan Yang,Wenzhe Li,Jun Liu,Yankun Sun,Wanzhen Liu
阅读全文 在 PubMed 查看

摘要

Adsorbents prepared by impregnating porous materials with polyethylenimine (PEI) are potential candidates for CO 2 capture from biogas. The objective of current research is to investigate the effect of structures of resins on CO 2 capture performance of PEI-impregnated resins from simulated biogas. Here, three commercially available resins (D101, X-5 and ADS-17) with different pore volumes or surface functional group were selected as supports. N 2 adsorption-desorption, infrared spectroscopy, scanning electron microscopy and thermal gravimetric analysis were used to characterize the resins before and after impregnating PEI. Breakthrough experiments revealed that all these PEI-impregnated resins could selectively adsorb CO 2 at ambient temperature. Meanwhile, PEI-impregnated ADS-17 exhibited a superior performance among the tested adsorbents, despite that it had the lowest BET surface area and total pore volume. It is mainly because that ADS-17 had uniform voids and carbonyl group, enhanced the dispersion of PEI and thus improved the CO 2 adsorption performance. In addition, ADS-17-20% PEI possessed excellent regenerability. The influence of gas flow rate and temperature on the CO 2 adsorption behavior upon ADS-17-20% PEI was also investigated. It was found that the adsorption capacity did not depend much on the flow rate when the gas flow rate ranging from 100 to 200 mL/min. When the temperature was increased from 25 to 45 °C, a slight increase in CO 2 adsorption was observed. Furthermore, CO 2 adsorption performance of ADS-17-20% PEI can be improved under humid condition.