Synthesis and Characterization of Biodegradable Polyester/Polyether WPU as the Environmental Protection Coating

Polyester diol PCL and PBA, polyether diol PTMG and polycarbonate diol PCDL were used as components of WPU soft segment, respectively. Polyether PTMG-WPU has the worst hydrolytic property and the highest thermal stability. The maximum degradation rate temperature Tmax is 407.8 °C, the water contact angle reaches 89.5 °. Traditional polyester PCL-WPU shows the strongest hydrolysis performance, the smallest water contact angle, only 71.7 °, the water absorption rate of 72 h at room temperature is as high as 26.7%. However, the thermal stability of PCL-WPU is lower, the soft segment Tg is −52.3 °C, and Tmax is only 333.7 °C, but the mechanical property of which is the best, the tensile strength is 58.3 MPa, and the elongation at break reaches 857.9%. The most important thing is that the structure of polyester PCL-WPU is more easily destroyed by lipase and water molecules. The acidic products produced after hydrolysis will further promote the degradation of polyester. Therefore, compared with other WPUs, PCL-WPU has the best biodegradability and the most obvious degradation effect under the same conditions. The degradation rate of PTMG-WPU after 30 days of degradation in 0.6% lipase PBS buffer solution and soil was only 4.2% and 2.3%, while the highest degradation rate of traditional polyester PCL-WPU reached 41.7% and 32.0%, respectively. In addition, polycarbonate PCDL-WPU has the highest hardness, reaching 95.5 HD. But its other performances are lower than PCL-WPU.