Comparison of the performance of prepared pristine and TiO2 coated UF/NF membranes for two types of oil-in-water emulsion separation

Polysulfone ultrafiltration (UF) and polypiperazine-amide nanofiltration (NF) membranes were first fabricated by phase inversion and interfacial polymerization, and then modified by the commonly used TiO 2 on the membrane surface, respectively. Compared with the pristine UF and NF membranes, pure water flux decreased by 40.66% for modified UF membrane and 12.92% for modified NF membrane, while the contact angle of the modified membranes decreased from 66.5° to 35.3° for UF membrane and from 48.2° to37.7° for NF membrane. However, the membrane modified by TiO 2 nanoparticles for both UF and NF membranes exhibited much better anti-fouling and separation performance for two types of oil-in-water emulsions with different droplet size (i.e., prepared oil-in-water emulsion with low salinity and oil produced water in Shengli oilfield, China). It was obvious that water flux of modified UF only slightly decreased and the stable water flux was 2.2 times and 15.6% higher than that of pristine membranes for the prepared oil-in-water emulsion and produced water, respectively. According to the five fouling models for UF, the TiO 2 modified UF membrane could alleviate the fouling on membrane surface and greatly increase water flux by reducing the adsorption, deposition, blockage of membrane pores and formation of cake layer for two types of oil-in-water emulsion. For NF, water flux of the modified membrane increased by 66.1% and 22.8% for prepared oil-in-water emulsion and produced water, respectively. TiO 2 coating effectively alleviated the oil adhesion and cake layer formation on the membrane surface.