摘要
In this work, we present a repair method of open circuit defects in precision circuitry using hot press sintering of copper particles followed by laser ablation. First, the open circuit defect position is filled with copper particle paste. Then, the copper particles are hot-press sintered to form conductive pathways. Finally, a high-power-density laser with a micron-sized beam spot is used to remove residual excess copper. With this method, open circuit defects with a length of 100 μm, a width of 100 μm, a line spacing of 80 μm, and a thickness of 45 μm can be successfully repaired. In contrast to the traditional circuit forming route that uses laser sintering of copper particles, the hot press sintering step promotes the closure of internal voids. As a result, a more compact sintered structure is obtained, and the formable circuit thickness, porosity, and electrical properties can be significantly improved. The as-repaired circuit region exhibits a low porosity of 14% and a low excess electrical resistance of 0.014 Ω, which corresponds to an electrical resistivity as low as 3.04 μΩ·cm. These results are significantly better than the circuit defects repaired by the laser sintering process, which results in an overall porosity of 45% and an electrical resistivity of 316.8 μΩ·cm. The circuit repair method presented here provides a promising technique for yield improvement and cost control for the manufacturing of precision circuits.
危险品化学品经营许可证(带存储)