摘要
Bifunctional surface modification strategy mitigated carbon fiber electrode corrosion in structural batteries. • Modified carbon fiber composites exhibited 17% stronger flexural strength and 28% higher modulus. • Structural battery achieved record 90.02% capacity retention after 1000 cycles at 2 C. • All-fiber based structural battery maintained stable capacity under 100-250 MPa cyclic mechanical loading. Carbon fiber reinforced composite structural batteries that integrate both mechanical load-bearing and energy storage capabilities will be prone to failure at the fiber/matrix interface. However, the interactions between carbon fiber (CF) electrodes and liquid (or polymer) electrolytes remain rarely explored. In this study, we examined the corrosion behavior between CF and liquid electrolyte, based on the assembled CF-based coin cell after cycling. Then, a surface modification strategy was employed to construct a bifunctional layer with carbon nanotubes and polytetrafluoroethylene (CNTs/PTFE) on CF surface. Mechanical flexural testing results for the modified CF composites exhibited ∼17% greater strength values, along with a 28% increase in modulus compared to those of unmodified. Furthermore, the electrochemical performance of a lithium iron phosphate (LFP)||Li half cell with modified CF as current collector was tested with a specific capacity of 163.4 mAh g −1 at 0.1 C (∼6% greater than unmodified sample). Also, excellent cycling stability was obtained, with 90.02% capacity retention after 1000 cycles at 2 C (representing the highest values reported to date for structural half cells). Finally, a structural battery of Graphite||LFP with modified CF as current collector exhibited stable capacity under cyclic loading ranging from 100 to 250 MPa and could be used in electrical devices. This work demonstrates the importance of fiber surface architecture for material-level innovation of structural batteries to achieve high performance. This study examines the corrosion behavior between carbon fiber electrodes and liquid electrolyte after cycling in structural batteries. A surface modification strategy is developed to construct a bifunctional protective layer on carbon fiber surfaces. This interface engineering approach represents a vital material-level innovation for structural batteries, enabling simultaneous achievement of enhanced mechanical and electrochemical performance. Download: Download high-res image (262KB) Download: Download full-size image
危险品化学品经营许可证(带存储)