摘要
Lightweight, ablation-resistant, and high-temperature insulating thermal protection materials are critically important for next-generation hypersonic vehicles. This paper proposes a novel gradient structure design strategy that achieves a combination of lightweight, ablation resistance, and high-temperature thermal insulation in ceramizable composites by introducing a gradient distribution of ZrSi 2 –MoSi 2 –B 4 C fillers. Compared with non-gradient ceramizable composite (CC), the gradient structure design reduced the density and thermal conductivity of the composite. Moreover, the ZrSi 2 –MoSi 2 –B 4 C modified carbon fiber/boron phenolic resin gradient ceramizable composite (GCC) exhibited superior ablation resistance and high-temperature insulation performance to carbon fiber/boron phenolic resin composites (CF/BPR). After 20 s of oxyacetylene ablation at 4.2 MW/m 2 , the linear and mass ablation rates were as low as 0.019 mm/s and 0.0279 g/s. After 600 s of butane torch ablation, the backside temperature reached only 397.1 °C, which was lower than that of CF/BPR (408.3 °C). The residual yield of the GCC at 1400 °C in air was 32.7%, significantly higher than that of CF/BPR (7.8%). Owing to the gradient structure design, an ablation-resistant multiphase ceramic layer formed on the surface, which not only enhanced ablation resistance but also blocked and radiated heat, reducing heat transfer. The inner layer, composed of low-density and low-thermal-conductivity CF/BPR, reduced the density and enhanced thermal insulation. This work provides some inspiration for the fabrication of thermal protection materials integrating lightweight, thermal protection, and insulation.
危险品化学品经营许可证(带存储)