摘要
Ni–W/CrN particle-reinforced coatings were effectively fabricated through composite electrodeposition using bath solution comprising dispersed CrN particles, yielding a novel candidate coating with promising performance for deep-sea environments. The influences of deposition mode and substrate type on the fabrication process, microstructure and anti-corrosion property of Ni–W/CrN coatings were systematically investigated. The electrochemical corrosion behaviors were evaluated in 3.5 wt% NaCl solutions at ambient temperature. Results revealed that intermittent electrodeposition significantly enhances coating compactness, refines grain size, and improves corrosion resistance. The resulting coatings present uniform and dense microstructures without cracks, displaying typical nodular or cauliflower-like morphologies, and possess an FCC solid-solution structure of nickel. Specifically, composites deposited on carbon steel substrates under intermittent conditions at 3–5 A·dm −2 displayed fine-grained microstructures, low defect density, and superior corrosion resistance. EDS analysis confirmed uniform distribution of CrN particles throughout Ni W metallic lattice. Compared to the intermittent coating, the continuously deposited coating exhibits a higher defect occurrence rate, including nanoparticle agglomeration and porosity. The intermittent coating contains 11.46–12.62 at.% W and 2.51–3.08 at.% CrN, 78.28–79.9 at.% Ni and a small amount of oxygen. The embedded CrN nanoparticles promote heterogeneous nucleation and induce microstructural refinement in the Ni W matrix. The average roughness ( R ₐ) of intermittent electrodeposition at 2 A·dm −2 was 36.6 nm, which was much lower than 616 nm for continuous electrodeposition at 3 A·dm −2 . R a of intermittently deposited coating on carbon steel, prepared at 3 and 5 A·dm −2 increased to 636 nm, indicating a strong dependence of surface topography on current density, substrate type, and deposition mode. Electrochemical evaluations identified the optimal processing parameters for achieving outstanding corrosion resistance: 15 g L −1 CrN, 3–5 A dm −2 , and intermittent electrodeposition mode. The embedded CrN nanoparticles could effectively fill microstructural defects (e.g., pores and microcracks) within the Ni W matrix, thereby enhancing physical barrier properties and overall corrosion resistance. These electrodeposited Ni–W/CrN nanocomposites exhibit exceptional fine and compact microstructure and superior performance, making them high promising candidates for protective coatings in aggressive service environments.
危险品化学品经营许可证(带存储)