TALANTA
·
2016
·
IF 4.035
Xialin Luo,Gongke Li,Yufei Hu
In this work, a novel NH 2 -MIL-53(Al) incorporated poly(styrene-divinylbenzene-methacrylic acid) (poly(St-DVB-MAA)) monolith was prepared via chemical fabrication. Moreover, it has been efficiently applied to the in-tube solid-phase microextraction (SPME) for online coupling with high-performance liquid chromatography (HPLC) to the direct determination of five estrogens in human urine samples. The NH 2 -MIL-53(Al)-polymer monolith was suitable for in-tube SPME owing to its good permeability, high extraction efficiency, chemical stability, good reproducibility and long lifetime. The extraction conditions including extraction solvent, pH of sample solution, flow rate of extraction and desorption, and desorption volume were investigated. Under the optimum conditions, the enrichment factors were 180–304 and saturated amounts of extraction were 2326–21393 pmol for estriol , 17β-estradiol, estrone , ethinyl estradiol and progesterone , respectively. The adsorption mechanism was also explored which contributed to its strong extraction to target compounds. The proposed method had low limit of detection (2.0–40 ng/L) and good linearity (with R 2 between 0.9908 and 0.9978). Four endogenous estrogens were detected in urine samples and the recoveries of all five analytes were ranged from 75.1–120% with relative standard deviations (RSDs) less than 8.7%. The results showed that the proposed online SPME-HPLC method based on NH 2 -MIL-53(Al)-polymer monolithic column was highly sensitive for directly monitoring trace amount of estrogens in human urine sample.
✓ 已验证
产品关联
DOI
PubMed
高影响因子
Inorganic Chemistry Frontiers
·
2026
·
IF 6.2
Chenyang Zhan,Zihao Wang,Sisi Liang,Zhi-Ying Zhao,Hanru Chen,Jiahe Yu,Haomiao Zhu
Alkaline earth lithoaluminates with the UCr4C4-type structure have demonstrated considerable potential in achieving narrow-band emissions from Eu 2+ . However, obtaining single-phase powder samples with green-emitting remains challenging. In this study, we address this issue by co-doping Ba 2+ into the novel UCr4C4-type system Sr5/6-xBaxLi17/6Al7/6O4:Eu 2+ , which significantly enhances phase purity and structural homogeneity. This approach not only reduces the emission bandwidth from 66 nm (2241 cm -1 ) to 51 nm (1830 cm -1 ) but also induces a blue shift to 529 nm, fine-tuning the emission into the desired deep green region. Through detailed mechanistic studies-including low-temperature spectroscopy and luminescence decay analysis-we identify the presence of multiple Eu 2+ emission centers associated with distinct Sr 2+ sites. Ba 2+ doping is shown to promote dominant Eu 2+ emission in the green spectral region, thereby facilitating spectral narrowing.The optimized phosphor achieves a high absorption efficiency of 64.6% and an external quantum yield of 22.2%. When integrated into a white LED prototype, it enables a color gamut covering 97.6% of the NTSC (National Television System Committee) standard, outperforming a commercial β-SiAlON:Eu 2+ -based device. This study provides an effective cationic codoping strategy for designing high-performance narrow-band oxide phosphors and highlights a promising candidate for nextgeneration display technologies.
✓ 已验证
产品关联
DOI
高影响因子
FUEL PROCESSING TECHNOLOGY
·
2022
·
IF 8.129
Jida Wang,Feng Shi,Can Liu,Yi Lu,Xu Lin,Defa Hou,Jirong Li,Dechao Wang,Zhifeng Zheng,Yunwu Zheng
In this study, a series of cost-effective and eco-friendly Ca-Mg-Al and Ni-modified Ca-Mg-Al catalysts were successfully synthesized with different methods (coprecipitation, impregnation and mechanical mixing method) and applied to catalytic pyrolysis vapor upgrading of oleic acid (OA) to produce gasoline-kerosene rich production using methanol as a hydrogen donor . In addition, the effects of the process parameters (catalyst type, OA to methanol ratio, pyrolysis/catalytic temperature, catalyst loading, feedstock injection volume) on the product yield and selectivity were explored, and the reuse properties and deactivation mechanism were also evaluated. Active Ni species coupled with methanol were more conducive to enhancing the catalyst activity and OA conversion and obviously increased the selectivity toward the gasoline-kerosene product. The impregnation method was favorable for the formation of NiAl 2 O 4 species, and coprecipitation method suppressed the formation of NiAl 2 O 4 species. The enhanced activity and deoxygenation selectivity of the coprecipitation method (NiCaMgAl) at lower pyrolysis temperatures was attributed to the abundant higher specific surface area and pore size, higher active metal oxide (Ni 2+ ) and well-active Ni dispersion with a smaller particle size, as well as the lower acidity and partially oxidized Ni, which suppressed the NiAl 2 O 4 spinel phase formation compared with the Ni/Ca-Mg/Al (impregnation) and Ca-Mg-Al (mixing) catalysts, which was beneficial to the decarbonylation/ decarboxylation reaction and inhibited the hydrocracking reaction of C C. Therefore, 100% conversion, 97.12% hydrocarbon yield, 54.53% gasoline and 58.80% kerosene content over NiCaMgAl catalyst were obtained under optimal conditions (pyrolysis/catalytic temperature = 450/500°C, catalyst loading = 1.5 g, feedstock injection volume = 0.1 ml/min and OA to methanol ratio = 3:1). Moreover, NiCaMgAl catalyst also demonstrated good reusability and hydrothermal stability performance due to the lower amount of coke deposition with a lower graphitized structure, which suppressed sintering.
✓ 已验证
产品关联
DOI
高影响因子
DALTON TRANSACTIONS
·
2022
·Vol. 52
·期 2
·376-383
·
IF 4.569
Enming Ping,Lingyun Kong,Mengyao Liu,Yunshan Zhou,Lijuan Zhang,Nan Chen
The reaction of porous γ-Al2O3 particles acting as both a sacrificial template and an aluminum source with 1,4-naphthalene diacid (H2NDC) resulted in the formation of γ-AlOOH@Al(OH)(1,4-NDC) composites, in which ZIF-67 was then loaded by the in situ crystallization method, leading to the formation of γ-AlOOH@Al(OH)(1,4-NDC)@ZIF-67 composites. The deliberately designed composite was used to separate H2/D2 at 77 K in a 1 m chromatographic column. The results demonstrated that the optimized composite can achieve the effective separation of H2/D2 in gas chromatography due to the additive effects of kinetic sieving and chemical affinity quantum sieving of Al(OH)(1,4-NDC) and ZIF-67. By optimizing chromatographic separation conditions, the resolution R reached 2.02 with the separation time t = 7.72 min. The composite also showed satisfactory repeatability and reproducibility.
研究领域:
材料科学
·
分离科学
·
物理化学
·
纳米材料
·
能源化学
✓ 已验证
DOI
高影响因子
TALANTA
·
2017
·
IF 4.162
Guihua Gao,Sijia Li,Shuo Li,Yudan Wang,Pan Zhao,Xiangyu Zhang,Xiaohong Hou
In this work, computational and experimental methods were used to study the adsorption of estrogens and glucocorticoids on metal–organic frameworks (MOFs). Computer-aided molecular simulation was applied to predict the adsorption of eight analytes on four MOFs (MIL-101(Cr), MIL-100(Fe), MIL-53(Al), and UiO-66(Zr)) by examining molecular interactions and calculating free binding energies. Subsequently, the four water-stable MOFs were synthesized and evaluated as adsorbents for the target hormones in aqueous solution. As the MOF exhibiting the highest adsorption capacity in both computations and experiments, MIL-53(Al) was chosen as a sorbent to develop a dispersive micro-solid-phase extraction procedure coupled to ultra-performance liquid chromatography tandem mass spectrometry for simultaneous determination of the target analytes in water and human urine samples. Experimental parameters affecting the extraction recoveries, including pH, ionic strength , MIL-53(Al) amount, extraction time, desorption time, and desorption solvent, were optimized. The optimized method provided a linear range of 0.005025–368.6 μg/L with good correlation coefficients (0.9982 ≤ r 2 ≤ 0.9992), and limits of detection (S/N = 3) and quantification (S/N = 10) of 0.0015–1.0 μg/L and 0.005–1.8 μg/L, respectively. The analyte recoveries were in the range of 80.6–98.4% in water samples and 88.4–93.2% in urine samples. Furthermore, MIL-53(Al) showed good stability over 10 extraction cycles (RSD < 10.0%). Good agreement between experimental measurements and computational results showed the potential of this approach for elucidating adsorption mechanisms and predicating extraction efficiencies for MOFs and targets, providing new directions for the development and utilization of MOFs.
✓ 已验证
产品关联
DOI
PubMed
高影响因子
危险品化学品经营许可证（带存储）