ANALYTICA CHIMICA ACTA
·
2022
·
IF 6.911
Lin Li,Hongyu Zhang,Mengdan Zhang,Ting Wang,Xiaohong Hou
MIL-88B(Fe)/cellulose microspheres (MIL-88B(Fe)/CMs) were characterized by the means of SEM, XRD, TGA and N 2 adsorption-desorption test. The composite was used as the sorbent for fully automated dispersive pipette extraction (DPX), after introducing CMs as the support, the loss of MIL-88B(Fe) in DPX was avoided. Coupled to UPLC-MS/MS, the proposed method was employed for the analysis of trace sulfonamides (SAs) in milk samples. The parameters affecting the extraction efficiency, including pH of sample solution, the rate of aspiration and dispense, amount of the adsorbent, type and volume of elution solvent were optimized. Under the optimal conditions, good linearity (r ≥ 0.9978 for five analytes), high sensitivity (limit of detection: 0.00660–0.0136 μg kg −1 ) and satisfactory recovery (69.8%–100.9%) were achieved. Furthermore, the sorbent showed desirable reusability over eight extraction cycles. Compared with other methods for the pretreatment of SAs, the proposed method showed advantages of high sensitivity, less sorbent consumption, environmental friendliness and automation, providing a promising protocol for sample preparation.
✓ 已验证
产品关联
DOI
PubMed
高影响因子
JOURNAL OF COLLOID AND INTERFACE SCIENCE
·
2022
·
IF 9.965
Xiaolong Hu,Jingyu Bao,Daiwen Chen,Syed Jalil Shah,Sidra Subhan,Wenxue Gong,Wenyuan Li,Xinqi Luan,Zhongxing Zhao :,Zhenxia Zhao
In the photo-Fenton reactions, fast recombination of photoinduced electrons and holes in Fe-based metal–organic frameworks (Fe-MOFs) slows Fe(III)/Fe(II) cycle, which remains big challenge that significantly retards the overall process. Herein, NH 2 -MIL-88B(Fe) (NM88) was modified with 3,5-diaminobenzoic acid (DB) and TPB-DMTP-COF (COF-OMe) to in situ construct NM88(DB) 0.85 /COF-OMe composite that could strongly harvest the visible light for photo-Fenton degradation of sulfamerazine (SMR). With the addition of DB, electron-donating effect of NM88 was strengthened, which then promoted amino groups to react with aldehyde groups (Schiff-base), and thus highly facilitated the interfacial contact between NM88 and COF-OMe. Such modifications increased the degradation rate constants for NM88(DB) 0.85 /COF-OMe to 15.1 and 17.3 times that of NM88 and COF-OMe respectively with good reusability. Moreover, the catalyst exhibited 32–170 times higher degradation kinetics in comparison to other reported catalysts. Results showed that due to the Schiff-base reaction between NM88(DB) and COF-OMe, electron density on Fe(III) was decreased; and the photogenerated electrons of COF-OMe moved to NM88(DB) to reduce Fe(III), thus resulting in the generation of highly active Fe(II) and ·OH species. Furthermore, the main reactive species were determined to be ·OH and ·O 2 – by trapping experiments, and a possible mechanism of the degradation system followed Z-scheme charge transfer.
✓ 已验证
DOI
PubMed
高影响因子
SEPARATION AND PURIFICATION TECHNOLOGY
·
2022
·
IF 9.136
Zhenfei Yang,Longlu Wang,Ming Fang,Xinnian Xia,Yutang Liu
The key to achieve an efficient cooperative photoredox reaction system is to elaborately construct high-efficiency multifunctional photocatalysts with the maximum carrier utilization. Herein, a well-design S-scheme MIL-88B (Fe)/ZIS heterojunction modified with amorphous CoS 1+x cocatalyst (CMZIS) was firstly successfully constructed. The CMZIS heterojunctions show a high H 2 evolution rate of 3164.9 μmol g −1 h −1 coupling with a benzaldehyde generation rate of 3417.8 μmol g −1 h −1 , which are 7.9 and 8.1 times higher than those of pure ZIS. The excellent performance of CMZIS heterojunctions benefits from the synergistic effect of S-Scheme heterojunction and CoS 1+x cocatalysts. This synergy realized the directional transfer and spatial separation of photogenerated carriers in CMZIS, thus inhibiting charge recombination and and maximizing the redox ability of charge carriers. Moreover, CoS 1+x cocatalyst offer more active sites and further enhance the H 2 evolution efficiency. This work will offer fresh insights to the construction and mechanism study of advanced multifunctional photocatalysts for the highly efficient cooperative photoredox reaction system.
✓ 已验证
DOI
高影响因子
COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS
·
2026
·
IF 5.4
Qing Jin,Kai Ma,Guilong Gao,Xinyu Zhou,Lijie Xu,Ying Zhang,Jiangtao Shi,Lu Gan
In this study, a series of carbon nanofiber (CNF) based one-dimensional catalysts were prepared by pyrolyzing MIL-88B(Fe) anchored PAN/lignin electrospun nanofibers, which were then employed to activate peroxymonosulfate (PMS) for bisphenol A (BPA) degradation. The results indicated that adjusting the lignin content in nanofiber precursor could engineer the crystalline phase of iron compounds in the catalysts, as well as their catalytic activity and stability. Specifically, the precursor with lower lignin content was converted into Fe 3 O 4 loaded CNF (P2L1-Fe-C), whereas Fe 3 C loaded CNF was obtained (P1L1-Fe-C) by increasing lignin content to 50 wt% in the nanofiber precursor. Having multiple Fe valence states within Fe 3 C which facilitated internal electron transfer, P1L1-Fe-C exhibited high catalytic activity with high stability and low iron ion leaching when activating PMS for BPA degradation. P1L1-Fe-C/PMS system could produce more kinds of active species including hydroxyl radical (•OH) and multiple non-radical species like singlet oxygen ( 1 O 2 ), high-valent iron-oxo species, and electron transfer process. Comparatively, P2L1-Fe-C/PMS system was only able to produce •OH and 1 O 2 . The existence of more BPA degradation pathways resulted in enhanced resistance of P1L1-Fe-C/PMS system towards various environmental interferences. This study inspires a new thinking of developing iron based Fenton-like catalyst with tunable crystalline phases through precursor recipe regulation, achieving both high activity and stability. Download: Download high-res image (225KB) Download: Download full-size image
✓ 已验证
产品关联
DOI
高影响因子
危险品化学品经营许可证（带存储）