计算溶液所需的质量、体积或浓度。
本产品为多重 PCR 扩增专用试剂盒,试剂中包含 Taq 热启动酶、多重 PCR buffer 以及 dNTP等,可满足多组引物在一个反应管中同时扩增的需求。
组分与储存:
| 组分货号 | 组分名称 | 物理外观 | 50T | 100T | 储存 |
| M1547897A | 5U/μL Taq 热启动酶 | 液体 | 50μL | 100μL | -20℃ 避免反复冻融 |
| M1547897B | 10×多重PCR buffer | 液体 | 250μL | 500μL | -20℃ 避免反复冻融 |
| M1547897C | 25mM MgCl₂ | 液体 | 500μL | 1mL | -20℃ 避免反复冻融 |
| M1547897D | 10mM dNTP | 液体 | 50μL | 100μL | -20℃ 避免反复冻融 |
| M1547897E | ddH₂O | 液体 | 1mL×2 | 1mL×4 | -20℃ 避免反复冻融 |
使用说明:
1. 准备:将 Taq 热启动酶、10× 多重 PCR buffer、10mM dNTP、引物、ddH2O、DNA 模板等平衡至室温,充分混匀并瞬时离心后,备用。
2. 按下表配制反应液:
备注:引物浓度应根据需要对其浓度进行优化和调整;不同种类的 DNA 模板所含靶基因拷贝数不同,必要时可进行梯度稀释确定最佳模板浓度。10× 多重 PCR buffer Mg²⁺的终浓度为 2 mM,如扩增效果不佳可适当优化,建议每次增加0.5 mM Mg²⁺浓度进行实验。 |
3. 反应液充分混匀后,取相应体积加入 PCR 反应管,上机扩增。
4. 推荐反应条件:
备注:不同扩增片段长度所需的延伸时间<500 bp 60s,<1500 bp 90s,>1500 bp 120s |
5. 结果检测:反应结束,取 8 μL 扩增产物进行琼脂糖凝胶电泳检测。
This product is a dedicated kit for multiplex PCR amplification. The reagents contain Taq hot-start enzyme, multiplex PCR buffer, dNTPs, etc., and can meet the requirement of simultaneous amplification of multiple primer sets in a single reaction tube.
Contents & Storage:
| Component No. | Component Name | Appearance | 50T | 100T | Storage |
| M1547897A | 5 U/μL Hot-Start Taq DNA Polymerase | Liquid | 50μL | 100μL | -20℃. Avoid repeated freeze-thaw cycles. |
| M1547897B | 10× Multiplex PCR Buffer | Liquid | 250μL | 500μL | -20℃. Avoid repeated freeze-thaw cycles. |
| M1547897C | 25 mM MgCl₂ | Liquid | 500μL | 1mL | -20℃. Avoid repeated freeze-thaw cycles. |
| M1547897D | 10 mM dNTP | Liquid | 50μL | 100μL | -20℃. Avoid repeated freeze-thaw cycles. |
| M1547897E | ddH₂O | Liquid | 1mL×2 | 1mL×4 | -20℃. Avoid repeated freeze-thaw cycles. |
Instructions for Use:
1.Preparation: Equilibrate the Taq hot-start enzyme, 10× Multiplex PCR Buffer, 10 mM dNTPs, primers, ddH₂O, and DNA template to room temperature. Mix thoroughly and briefly centrifuge before use.
2.Prepare the reaction solution according to the following table:
Note: Primer concentrations should be optimized and adjusted as needed. Different types of DNA templates contain different copy numbers of the target gene; if necessary, perform gradient dilution to determine the optimal template concentration. The final Mg²⁺ concentration of the 10× Multiplex PCR Buffer is 2 mM. If the amplification performance is unsatisfactory, it can be further optimized; it is recommended to increase the Mg²⁺ concentration by 0.5 mM each time |
3.After the reaction solution is thoroughly mixed, add the appropriate volume to a PCR reaction tube and run the amplification on the instrument.
4.Recommended Reaction Conditions:
Note: The extension time required for different amplification fragment lengths: <500 bp, 60 s; <1500 bp, 90 s; >1500 bp, 120 s. |
5.Result Detection: After the reaction is complete, take 8 μL of the amplification product for agarose gel electrophoresis detection.
| 组分货号 | 组分名称 | 物理外观 | 50T | 100T | 储存 |
| M1547897A | 5U/μL Taq 热启动酶 | 液体 | 50μL | 100μL | -20℃ 避免反复冻融 |
| M1547897B | 10×多重PCR buffer | 液体 | 250μL | 500μL | -20℃ 避免反复冻融 |
| M1547897C | 25 mM MgCl₂ | 液体 | 500μL | 1mL | -20℃ 避免反复冻融 |
| M1547897D | 10 mM dNTP | 液体 | 50μL | 100μL | -20℃ 避免反复冻融 |
| M1547897E | ddH₂O | 液体 | 1mL×2 | 1mL×4 | -20℃ 避免反复冻融 |
我们的级别选择指南涵盖了目录中所有的变体的纯度、稳定剂状态和应用适用性。
查看 BioReagent 级别指南 → 查看 PCR Reagent 级别指南 → 查看 Suitable for molecular biology 级别指南 →