已核实 DOI 相关产品: 18

A Microstructured-Enhanced Flexible Sensor With Integrated Sensing and Adhesion for UAV Status Monitoring

Journal 2026 · IF 6.2 · 发表于 2026 年 1 月 24 日
作者: Qiyun Zhong,Yangyang Li,Diyi Liu,Xinyu Lu,Siyuan Liu,Yuze Ye,Fengjiang Zhan,Cheng He,Xiaodong Xu,Qingsong He
阅读全文 在 PubMed 查看

摘要

Flexible sensors are pivotal to advancements in intelligent robotics, health monitoring, and aerospace. Conventional sensors struggle to balance wide-range detection and integrated adhesion, so this study proposes a microstructure-enhanced polyvinyl chloride/multi-walled carbon nanotubes (MWCNTs) polymer gel (MPG) sensor. It achieves integrated sensing and adhesion by fabricating a microcolumn array with a diameter of 20 µm and a height of 60 µm. The microstructures boost interfacial adhesion up to 301 mN/cm 2 via increased contact area and convert mechanical deformation into electrical signals efficiently for pressure sensing using high aspect ratio. At 0.4 wt% MWCNTs content, the sensor shows optimal performance. It delivers an output voltage of 4.7 V under 100 kPa and a response time of 173 ms. Even at 0.2 wt% MWCNTs content, it maintains stable output after 600 compression cycles, with a mechanical recovery rate of ≥96% and excellent thermal stability. Its effectiveness and application potential in complex scenarios are verified by micro-UAV negative-surface adhesion landing tests and dynamic wing data acquisition of fixed-wing UAVs throughout taxiing, takeoff, cruising, and landing. This research provides new solutions for flexible electronics, intelligent robotics, and aerospace structural health monitoring.

本研究中使用的阿拉丁产品

18 款产品在本文中被引用