已核实 DOI PubMed 相关产品: 4

Starch granular hydrogels with enhanced mechanical properties and 3D printing performance: Fabrication and characterization

Journal 2026 · IF 13.2 · 发表于 2026 年 7 月 9 日
作者: Ying Wang,Ziyun Zhao,Man Li,Yang Qin,Liu Xiong,Qingjie Sun
阅读全文 在 PubMed 查看

摘要

Traditional bulk starch hydrogels have weak mechanical properties and poor printability. In this study, ethanol-annealed potato starch was used to construct starch granular hydrogels (12–20% w / v ). At 15%, the starch granular hydrogel (SGH 15 ) exhibited significantly higher hardness (1390.52 g vs. 245.28 g), storage modulus (5202.90 Pa vs. 107.19 Pa), and relative crystallinity (13.0% vs. 10.9%) than traditional potato starch hydrogel (PSH 15 ). Cryo-SEM revealed that, unlike traditional bulk hydrogel networks, the starch granular hydrogel consists of densely packed swollen starch granules with pore sizes ranging from 0.02 to 0.88 μm, which are smaller than those of PSH 15 (0.77–3.12 μm). With increasing concentration from 12% to 20%, the granular hydrogels exhibited progressively higher hardness, modulus, and crystallinity, while the pore size decreased. All granular hydrogels exhibited strong gel behavior (tan δ < 0.1), unlike PSH 15 (tan δ > 0.1). Notably, SGH 12 and SGH 15 (12% and 15% granular hydrogels) exhibited favorable thixotropic recovery and printability, forming stable 3D structures, whereas PSH 15 collapsed. This study developed starch granular hydrogels in which swollen starch granules act as structural units to reinforce the hydrogel network, providing a novel approach to designing starch-based materials with enhanced mechanical properties and superior 3D printing performance.

本研究中使用的阿拉丁产品

4 款产品在本文中被引用