摘要
Oil spills, sewage discharge, and organic solvent leakage pose serious threats to ecosystems and resource sustainability. However, most oil-absorbing sponges rely on costly modifications or nonrenewable petroleum-based raw materials. Here, we develop an all-lignocellulosic superhydrophobic wood sponge by integrating lignin nanospheres into a wood scaffold via liquid-phase deposition and stabilizing them with poly(dimethylsiloxane), achieving a low-cost and sustainable platform for oil–water separation. The obtained wood sponge combines superhydrophobicity, and high porosity, featuring a high water contact angle of 153.28° and exceptional coating robustness against extreme pH (2–12), wide temperature ranges (20–170 °C), and prolonged fluid impact (18 h), showing near-complete stress recovery at 30–50% strain and maintaining structural integrity over 150 compression cycles at 40% strain without plastic deformation. When the wood sponge was used for oil–water separation, it exhibited efficient oil adsorption above and below water with a high capacity of 6534.24 mg g–1 and sustained separation efficiencies of ∼89% (submerged) and ∼95% (exposed) over 10 cycles, alongside stable adsorption over 20 cycles. Simultaneously, the incorporation of lignin nanospheres imparts excellent photothermal performance to the superhydrophobic sponge, rapidly reaching 70.8 °C within 5 min under 1.5 kW m–2 irradiation and maintaining stable efficiency over 10 cycles, thereby boosting the adsorption rate of viscous reagents by about 4.0 times under illumination. The superhydrophobic wood sponge provides a promising and practical candidate for offshore crude oil spill remediation.
危险品化学品经营许可证(带存储)