摘要
The novel 1,3-diol extractant exhibits 95% lower water solubility than the conventional diol TMPD. • Direct boron extraction from raw salt lake brine is achieved at pH ≤ 8 without acidification pretreatment. • A continuous process using raw brine yields both boron extraction and stripping efficiencies exceeding 98%. • The extractant shows excellent hydrophobicity and stability over 10 cycles, with strong industrial application potential. Aliphatic diols are widely recognized as high-performance extractants for boron recovery. However, their industrial implementation is severely hampered by the inherently high aqueous solubility of currently available diol-based extractants. In this work, a novel aliphatic 1,3-diol was designed and synthesized, in which the functional moieties essential for boron chelation were fully retained, while its dissolution loss into the aqueous phase was substantially mitigated by extending the alkyl chain length. The boron extraction performance of the as-synthesized extractant was systematically investigated in both synthetic boric acid solutions and raw salt lake brine, with particular emphasis on the effects of key operational variables, including extractant concentration, organic-to-aqueous phase ratio (O/A), temperature, pH, and salting-out effect, on extraction efficiency. Total organic carbon (TOC) analysis revealed that the aqueous solubility of the novel 1,3-diol was reduced by 95% relative to that of the widely used aliphatic 1,3-diol TMPD. Thermodynamic analysis based on the van’t Hoff equation demonstrated that the extraction process is exothermic (ΔH < 0), indicating that elevated temperature shifts the equilibrium unfavorably for boron extraction. This extraction system exhibits outstanding extraction performance at pH ≤ 8, enabling direct boron recovery from raw salt lake brine without any pre-acidification. Coexisting cations in brine, including Li + , Na + , K + , Ca 2+ , and Mg 2+ , all exerted a promoting effect on boron extraction. Using raw brine from the Xitaijiner Salt Lake as the feedstock, a full-process flowsheet test comprising three-stage extraction, one-stage scrubbing, and one-stage stripping was conducted, achieving both boron extraction and stripping efficiencies exceeding 98%. Ten consecutive cycling tests confirmed that the developed extractant possesses excellent cycling stability and hydrophobicity, demonstrating promising potential for industrial-scale boron recovery.
危险品化学品经营许可证(带存储)