INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH
·
2021
·
IF 3.764
Wuyuan Liu,Zihan Gao,Xiangyun Zhao,Jiajian Gao,Runnong Yang,Lin Yu
The Cr-doped CeO2–TiO2 catalysts (CrCeTi) were produced via a coprecipitation method and used for selective catalytic reduction (SCR). The CrCeTi catalyst has good catalytic performance and sulfur resistance. The results of X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET), NH3-TPD, NO-TPD, X-ray photoelectron spectroscopy (XPS), and H2 temperature-programmed reduction (H2-TPR) suggested that the CrCeTi catalyst with high specific surface area (SSA), strong surface acidity, enhanced redox properties, and effective electron transfer (3Ce4+ + Cr3+ ↔ 3Ce3+ + Cr6+) were the important promotion factors for excellent SCR properties. The in situ diffuse reflectance infrared spectroscopy (DRIFTS) indicated that the incorporation of Cr could improve the adsorption capacity of nitrate and the activation capacity of NH3, which were conducive to enhancing the catalytic activity. The thermogravimetric analysis-mass spectrometry (TG-MS) confirmed that the doping of Cr reduced SO2 surface adsorption and promoted the decomposition of NH4HSO4 (ABS). Therefore, the CrCeTi catalyst showed excellent resistance to SO2 poisoning.
研究领域:
环境科学
·
催化化学
✓ 已验证
产品关联
DOI
高影响因子
CHINESE JOURNAL OF CATALYSIS
·
2018
·
IF 3.525
Lei Chen,Ding Weng,Jiadao Wang,Duan Weng,Li Cao
The CeO 2 -TiO 2 (CeTi) and CeO 2 /WO 3 -TiO 2 (CeWTi) catalysts were prepared by a sol-gel precipitation method and their NH 3 -NO/NO 2 selective catalytic reduction (SCR) performance was studied. N 2 O formation and effect of oxygen concentration on SCR performance over CeWTi catalyst were also investigated while varying the NO 2 /NO x ratio. Results indicate that fast SCR behavior of CeWTi catalyst has the best NH 3 -NO/NO 2 SCR performance due to the catalyst reoxidation rate by NO 2 higher than by O 2 . Compared with CeTi catalyst, CeWTi catalyst exhibits higher de-NO x performance under NH 3 -NO/NO 2 SCR conditions. As the CeTi and CeWTi catalysts exhibit similar redox property, addition of WO 3 provides more acid sites which accelerate the reaction between NH 4 NO 3 and NO to get a superior low-temperature activity. Amount of N 2 O formation shows a peak at 250 °C mainly derived from NH 4 NO 3 decomposition.
研究领域:
催化劑科學
·
環境工程
✓ 已验证
产品关联
DOI
高影响因子
JOURNAL OF RARE EARTHS
·
2019
·
IF 2.846
Lei Chen,Ding Wang,Jiadao Wang,Duan Weng,Li Cao
The CeO 2 -TiO 2 (CeTi) and CeO 2 /WO 3 -TiO 2 (CeWTi) catalysts were prepared by sol-gel method. The as-prepared catalysts were hydrothermally treated at 760 °C for 48 h in air containing 10 vol% H 2 O to obtain the hydrothermal aged catalysts. The sulfur aged catalysts were treated at 400 °C with 100 ppm SO 2 , 10% water vapor, air balance for 48 h and catalysts. The powder X-ray diffraction (XRD) and Raman results indicate that the crystallization of hydrothermal aged catalysts is more serious than sulfur aged catalysts. In addition, tungsten species can stabilize the CeTi catalyst from grain growth. According to the results of in situ diffuse reflectance infrared Fourier transform spectra (DRIFTS), temperature-programmed desorption of ammonia (NH 3 -TPD), H 2 temperature-programmed reduction (H 2 -TPR) and ammonia oxidation , the aging process leads to loss of surface area, redox properties, surface acidities and surface ceria concentration, especially for the hydrothermal aging. The NH 3 -NO/NO 2 SCR performances of sulfur aged catalysts are better than that of hydrothermal aged catalysts. Compared with CeTi catalyst, the addition of tungsten inhibits the crystallization of catalyst. So that more acid sites and active sites are retained. This is also the reason why tungsten addition improves the NH 3 -NO/NO 2 SCR performance of CeTi catalyst.
研究领域:
催化化学
·
环境科学
✓ 已验证
产品关联
DOI
高影响因子
APPLIED CATALYSIS A-GENERAL
·
2018
·
IF 4.521
Li Cao,Lei Chen,Xiaodong Wu,Rui Ran,Tengfei Xu,Ze Chen,Duan Weng
The CeO 2 /TiO 2 catalyst was prepared by a deposition-precipitation method, which exhibited high low-temperature activity under the fast SCR condition. By using transient reaction analysis (TRA), the steps in the fast SCR, including NO 2 adsorption and decomposition, reaction between nitrates and NO, ammonium nitrate formation and reduction by NO, were investigated. Diffuses reflectance infrared Fourier transform spectroscopy (DRIFTS) experiments, via NO + O 2 or NO + NO 2 adsorption, ammonium species reaction with NO x and NO reaction with NH 4 NO 3 , were designed to identify the roles of NO, NO 2 and NH 3 in fast SCR. Based on L-H mechanism, the NH 4 NO 3 formation played an important role in low-temperature SCR reaction. Compared with the behavior in standard SCR, the higher activity in the presence of NO 2 was ascribed to the faster NH 4 NO 3 formation rate and larger amounts of nitrates/nitrites. This phenomenon provided a basis for developing Ce-based catalysts as SCR catalysts for diesel exhaust aftertreatment.
研究领域:
催化化学
·
环境科学
✓ 已验证
产品关联
DOI
高影响因子
CHEMICAL ENGINEERING JOURNAL
·
2022
·
IF 16.744
Wen Luo,Jing Rong,Wanxia Zhao,Keke Kang,Lulu Long,Xiaojiang Yao
CeO 2 –TiO 2 catalysts with four different morphologies were successfully synthesized by a hydrothermal method and tested for selective catalytic reduction of NO x with NH 3 (NH 3 –SCR). For the four catalysts, CeO 2 –TiO 2 nanocubes (CT–NC) and nanorods (CT–NR) preferentially exposed {1 0 0} and {1 1 0} facets, respectively; furthermore, nanosheets (CT–NS) and nanospheres (CT–NH) mainly exposed {1 1 1} facet. Interestingly, CT–NH catalyst showed the best NH 3 –SCR performance and the NO x conversion exceeded 97% at 325 °C. Through a series of characteristic methods manifested that the short–range ordered structure of Ce–O–Ti in CT–NH catalyst provided stronger surface acidic sites to promote the high–temperature activity. Moreover, the abundant Ce 3+ species and appropriate reduction ability on {1 1 1} facet of CT–NH catalyst also caused outstanding de NO x activity. Reaction mechanism study showed that the Langmuir–Hinshelwood (L–H) mechanism and Eley–Rideal (E–R) mechanism existed simultaneously on all catalysts in NH 3 –SCR reaction. Meaningfully, two types of E–R mechanism were present on CT–NH catalyst, while L–H mechanism was dominant.
研究领域:
催化化学
·
环境科学
✓ 已验证
产品关联
DOI
高影响因子
APPLIED SURFACE SCIENCE
·
2025
·
IF 6.9
Shibo Yu,Yiqing Zeng,Mengna Zhan,Shule Zhang,Zhaoxiang Zhong
The influence of phosphorus (P) on ammonia selective catalytic reduction (NH 3 -SCR) catalysts has been the subject of considerable scrutiny. Nevertheless, the precise mechanism of its influence remains a matter of contention. Furthermore, the impact of introducing P at varying stages during catalyst preparation process and its different sites within the catalyst structure on performance is frequently disregarded, significantly hindering practical guidance for designing effective modified catalysts. In this study, a series of P-modified CeO 2 /TiO 2 catalysts were synthesized by introducing P at different preparation stages, and various of characterization and comparison experiments were conducted to elucidate the effect of introducing P at different stages on NH 3 -SCR performance of NO x . Results show that introducing P before loading CeO 2 boosts catalyst activity, whereas delaying the introduction of P results in decreased activity and a progressive decline in catalyst performance as the sequence of P introduction is postponed. P introduced earlier tends to be distributed on the surface of the TiO 2 support, which contributes to the dispersion and anchoring of Ce species. In contrast, when the introduction of P was delayed, it tended to be distributed on the surface of the active species, which led to pore plugging and active sites being covered. Secondly, the variation in loading sites resulting from alterations in the stage of P introduction significantly affected on the chemical environment of Ce species, leading to notable differences in the redox capacity of the catalysts. This is the primary reason for the considerable discrepancy in the SCR performance of the catalysts. This study revealed the sensitivity of the stage of P introduction to CeO 2 /TiO 2 catalysts, providing new insights for designing modified CeO 2 /TiO 2 catalysts.
研究领域:
催化化学
·
环境科学
✓ 已验证
产品关联
DOI
高影响因子
Catalysis Science & Technology
·
2022
·Vol. 12
·期 4
·1245-1256
·
IF 6.177
Jie Yang,Shan Ren,Mingming Wang,Zhichao Chen,Lin Chen,Lian Liu
Ce–Ti catalysts were considered as a promising replacement for V–Ti based catalysts for selective catalytic reduction (SCR) of nitrogen oxides (NO and NO2) with NH3. In this work, a CeO2/TiO2 catalyst was prepared by the impregnation method and studied by a series of in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) experiments. The results showed that CeO2 particles grew along TiO2 faces and amorphous cerium in the lattice of TiO2, both of which are present on the CeO2/TiO2 catalyst. NH4+ might adsorb on the Ti–O–Ce structures or TiO2–CeO2 interface as Brønsted acid sites, while two types of NH4+ species were distinguished by the time-resolved spectroscopic method due to the different increasing trends. Based on the temporal evolution transient in situ DRIFTS spectra, L-NH3 had higher activity than coordinated NH3 species, which suggested that gas phase NO reacted preferentially with L-NH3. The NH4NO3 intermediate dominated the SCR reactions over the CeO2/TiO2 catalyst, which followed the Eley–Rideal mechanism.
研究领域:
催化化学
·
环境科学
✓ 已验证
产品关联
DOI
高影响因子
Catalysts
·
2021
·Vol. 11
·期 4
·445
·
IF 4.146
Yangyang Guo,Xiaofei Xu,Hong Gao,Yang Zheng,Lei Luo,Tingyu Zhu
Ca poisoning behavior is inevitable for high-calcium content flue gas, so V2O5-WO3/TiO2(VWT) and V2O5-WO3-CeO2/TiO2(VWCeT) catalysts with different vanadium content have been prepared and the Ca-doped catalysts are compared in this manuscript. The result shows Ce addition can both promote the NO conversion and the alkali resistance. Lower Ca addition for 0.1VWCeT catalyst promotes its oxidability and Ce modification is more suitable for low vanadium catalysts. The total acidity and the reducibility of catalysts decline after Ca doping, and the reducibility of the active species on catalysts has been strengthened by Ce addition. CeO2based catalysts with lower Ca loading struggle to resist sulfur poisoning, while higher Ca loading favors SO2adsorption and also physically reduces the cerium acidification process. In the presence of SO2, additional Brønsted acid sites are formed in Ca rich catalyst. The dynamic NH3adsorption has been investigated, shows that Ca doping content on catalyst is critical for SCR reaction, and the catalyst is more susceptible to SO2initially in alkali flue gas during the actual application, but the sulfur resistance may increase with the alkali-poisoning effect aggravated by Ca doping.Keywords:Ca-poisoning;SCR reaction;NO reduction;V2O5-WO3/TiO2and V2O5-WO3-CeO2/TiO2catalysts;SO2and water;NO removal efficiency
研究领域:
环境科学
·
催化化学
✓ 已验证
DOI
高影响因子
ACS Applied Materials & Interfaces
·
2014
·
IF 5.9
Lei Chen,Zhichun Si,Xiaodong Wu,Duan Weng
A CuO–CeO2–TiO2 catalyst for selective catalytic reduction of NOx with NH3 (NH3-SCR) at low temperatures was prepared by a sol–gel method and characterized by X-ray diffraction, Brunner–Emmett–Teller surface area, ultraviolet–visible spectroscopy, H2 temperature-programmed reduction, scanning electron microscopy and in situ diffuse reflectance infrared Fourier transform spectroscopy (in situ DRIFTS). The CuO–CeO2–TiO2 ternary oxide catalyst shows excellent NH3-SCR activity in a low-temperature range of 150–250 °C. Lewis acid sites generated from Cu2+ are the main active sites for ammonia activation at low temperature, which is crucial for low temperature NH3-SCR activity. The introduction of ceria results in increased reducibility of CuO species and strong interactions between CuO particles with the matrix. The interactions between copper, cerium and titanium oxides lead to high dispersion of metal oxides with increased active oxygen and enhanced catalyst acidity. Homogeneously mixed metal oxides facilitate the “fast SCR” reaction among Cu2+–NO, nitrate (coordinated on cerium sites) and ammonia (on titanium sites) on the CuO–CeO2–TiO2 catalyst at low temperatures.
研究领域:
环境催化
·
材料化学
·
表面科学
·
化学工程
·
大气污染控制
✓ 已验证
DOI
高影响因子
危险品化学品经营许可证（带存储）